Fibre optic interconnecting devices and passive components - Part 05: Investigation on impact of contamination and scratches on optical performance of single-mode (SM) and multimode (MM) connectors
Introduction: Contaminated optical connectors result in degradation of optical performance, which can be quantified by return loss (RL) and attenuation (A), functional failures and increased deployment costs. Fibre optic connector endface cleaning is recognized as a necessity for optimal signal performance. It is known that contamination impacts signal performance by blocking the core and impeding light transmission, as well as by preventing direct physical contact creating an air gap between the two connector enfaces [1, 2]1. If an air gap exists, optical performance will be impacted due to the change in transmission medium. As contaminated connectors are mated and demated, contamination can be redistributed around the connectors’ endface and block the fibre core. This presents a risk of signal performance degradation during the service life. Since 2002, the iNEMI (International Electronics Manufacturing Initiative) working group has done substantial work, both theoretical and experimental, on impact of scratches and contamination on connector optical performance (A and RL). The following connector types have been used for this research: single-mode (SM) physical contact (PC) connectors, SM angle polished connectors (APC) and SM APC MPO connector. The impact of polishing scratches has been investigated for SM and multimode (MM) connectors. The work presented in this technical report was used as a base work for the development of IPC-8497-1 [3] and IEC 61300-3-35 [4]. _____________ Figures
Scope: This part of IEC 62627, which is a technical report, summarizes the extensive industry research on development of cleanliness specifications for single-mode (SM) and multimode (MM) connectors. The summary of the result shows Table 1. Table 1 – Summary of the result Samples Scratch/Contamination/Defect A/RL Clause Reference SM/MM Single-fibre/ multi-fibre SM PC Single-fibre Scratch RL [1], [5], [6] MM PC Single-fibre Scratch RL [7] SM PC Single-fibre Contamination A and RL [2], [6]. [8] SM APC Single-fibre Contamination [11] SM APC Single-fibre Scratch RL 7.2 [11] SM APC Multi-fibre Contamination A and RL [12]
Contents:
- FOREWORD
- INTRODUCTION
- Scope