Wind energy generation systems – Part 11-2: Acoustic noise measurement techniques – Measurement of wind turbine sound characteristics in receptor position
Introduction: The primary objective of this document is to establish uniform measurement and data analysis techniques to facilitate the evaluation of the A-weighted sound pressure level, or other acoustical properties, attributable to wind turbines at representative far-field locations. While this is a seemingly simple objective, wind turbines require wind to operate and the presence of wind complicates reliable acoustical measurements, either directly through wind induced microphone noise or indirectly through wind induced vegetative rustling sound. The presence of other common environmental sounds (planes, trains, road traffic, industrial, agricultural activities, etc.) can complicate or adversely influence the measured sound level. Owing to the distance of sound propagation, the meteorological conditions have a significant impact on the measurement results and the influence should be considered. Given that the regulatory requirements and history vary from country to country (and even within the same country), this document does not dictate regulatory metrics, but provides guidance on how best to isolate the sound attributable to wind turbines alone in the presence of other environmental sounds. It also provides guidance for those whose regulatory history for wind or other sources require the evaluation of specific acoustical aspects that have historically been subject to highly varying methodologies. Some countries have substantial experience with wind turbines while other countries are
Scope: This part of IEC 61400-11 presents measurement procedures, that enable the sound characteristics of a wind turbine to be determined at receptor (immission) locations. This involves using measurement methods appropriate to sound immission assessment at far-field locations of a wind turbine or wind farm. The procedures described are different in some respects from those that would be used for noise assessment from other industrial sound sources in environmental noise impact assessments. They are intended to facilitate characterization of wind turbine sound with respect to a range of wind speeds and directions. The procedures present methodologies that will enable the sound immission and sound characteristics of wind turbines to be described in a consistent and accurate manner. These procedures include the following aspects: location of acoustic measurement positions (receptor position); requirements for the acquisition of acoustic, meteorological, and associated wind turbine operational data; analysis of the data obtained and the content for the data report; and definition of specific acoustic parameters, and associated descriptors which are used for making environmental assessments. This document is not restricted to wind turbines of a particular size or type. The procedures described in this document allow for the thorough description of the sound characteristics and sound immissions from wind turbines.
Contents:
- FOREWORD
- INTRODUCTION
- Scope