IEC TS 61400-4-1-2026 PDF

IEC TS 61400-4-1-2026 PDF

Wind energy generation systems - Part 4-1: Reliability assessment of drivetrain components in wind turbines

$163.93 $327.86 -50%
Product Code: IEC TS 61400-4-1
Stock In Stock
Edition: 1.0
Published: 02/2026
Number of Pages: 40
File Size: 1 file, 1 Byte

Available Options

Product Description

Wind energy generation systems - Part 4-1: Reliability assessment of drivetrain components in wind turbines

Introduction: Gearboxes historically have been and still are a large contributor to wind turbine operating expenses and downtime. IEC 61400-4 describes requirements for the specification, design, and verification of gearboxes in wind turbines. This Technical Specification (TS) accompanies IEC 61400-4 and describes a method for the calculation of the design reliability of gearboxes for wind turbines. The method enables comparison of the calculated reliability of gearbox designs as a function of time. It allows gearbox suppliers, wind turbine manufacturers, wind plant owners, and others to compare different gearbox designs on equal terms. For example, the design reliability can be compared between different gearbox designs for the same load conditions or for the same gearbox in different load conditions. Wind turbine manufacturers and operators can also use the information for defining field service and repair strategies. Currently, that occur in the field have a standardized or generally accepted calculation method (Hovgaard 2015). Therefore, as illustrated in Figure 1, there is a difference between the calculated failure probability and apparent failure probability observed in the field. Figure 1 – Calculated design versus apparent failure probability The method described in this document can accommodate additional failure modes in the future, as long these modes are calculable according to a standardized method and are time related. Figure 1 also indicates how the inclusion of additional

Scope: This part of IEC 61400 specifies a method to calculate the design reliability of wind turbines gearboxes covered by IEC 61400-4, based upon failure modes where standardized calculation methods are publicly available. Currently, not all failure mechanisms that occur in the field have accepted theoretical models. Therefore, the method only provides a quantitative assessment method of the failure mechanisms that can be described with accepted mathematical models for the complete gearbox, stages (functional units), field replaceable units, and individual components. For the calculable failure mechanisms, it is possible to compare the reliability between different gearbox designs within the limitations of the theoretical models. The use of field-based statistical parameters can improve the accuracy of the calculated reliability. The calculated design reliability can provide information for the lifecycle management strategy. However, this document does not provide trade-off decisions between higher design reliability and maintenance strategies (e.g. preventive or predictive maintenance). This document does not consider repairable system analysis. Due to the lack of accepted theoretical models for some failure modes, the model can currently not predict the apparent failure probability in the field. Neither this document nor IEC 61400-4 specify a minimum value of design reliability.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TS 61400-4-1-2026 PDF

IEC TS 61400-4-1-2026 PDF

$163.93 $327.86