Portable and hand-held multimedia equipment Mobile computers Battery run-time measurement
Introduction: Adequate indication of the remaining battery level is crucial for mobile equipment, as its malfunction may lead to loss of user data. The wireless communication function of the mobile equipment causes the power dissipation to be larger and more irregular. A reliable indication of the remaining battery level is, therefore, strongly needed.
Scope: This Technical Specification defines the operation-mode mix of portable and hand-held multimedia equipment which can be driven by battery, especially mobile personal computers, in order to clarify the issues to be standardized on the battery run time. Battery run-time measurement methods for mobile PCs 2.1 General Current products have a variety of methods for setting power management as shown in Figure 1, and screens may differ from this example. If this is the case, the settings which most closely match the example should be used. The battery run time should be calculated as follows. [(measurement method a) + (measurement method b)]/2 The result should be rounded downward to one decimal point, and the result displaced as x.y. It is acceptable to use the term "approximately" or "about." Example: Measurement method (a) 3 h 15 min, measurement method (b) 8 h 7 min (195 min + 487 min)/2 = 5,683 h This should be rounded down to 5,6 h (or about 5,6 h). It is necessary to disclose all information on settings which are different from the factory shipping default. Examples of disclosure: by the Web, by an information centre, or by brochure. The margin on the measured value to the published value should not be defined. Figure 1 – Power option properties Power Option Properties Turn off hard disks System stand by Turn off monitor Never After 30 mins Never Close IEC 582/05