IEC TS 62607-6-33-2025 PDF

IEC TS 62607-6-33-2025 PDF

Nanomanufacturing - Key control characteristics - Part 6-33: Graphene-related products - Defect density of graphene: electron energy loss spectroscopy

$163.93 $327.86 -50%
Product Code: IEC TS 62607-6-33
Stock In Stock
Edition: 1.0
Published: 10/2025
Number of Pages: 38
File Size: 1 file, 3 Bytes

Available Options

Product Description

Nanomanufacturing - Key control characteristics - Part 6-33: Graphene-related products - Defect density of graphene: electron energy loss spectroscopy

Introduction: Quantitative and qualitative measurement of graphene defect is one of the most important factors to determine the quality of graphene. This document presents an analytical method for measuring local defect of graphene or graphene-related materials using scanning transmission electron microscopy (STEM) with electron energy loss spectroscopy (EELS). The scanning capability used in this method enables the defect distribution to be analysed, which can be used in determination of graphene quality. This document will be strengthened and compensated by other methods, such as Raman spectroscopy, X-ray photoelectron spectroscopy (XPS), optical microscopy, etc., which have already been standardized in IEC TC 113. STEM-based EELS uses electron beams with sub-nanometre scale, which allows structural observations within a highly localized area. Therefore, it is suitable for tracking important defect information that occurs at the atomic scale. Unlike other macroscopic analytical tools (e.g. Raman and XPS), the EELS method sets a clear boundary between graphene and defects that are induced by lattice transformation, doping, and adatoms. Moreover, the method determines the classification and quantity of defects including the number of holes and amorphous regions. These characteristics would complement the existing standards for measuring the defect density in graphene. Particularly, the advancements in STEM-EELS instruments, combined with large-scale data processing technologies, can signif

Scope: This part of IEC TS 62607 establishes a standardized method to determine the key control characteristic defect density (%, nm2) of single layer graphene films by electron energy loss spectroscopy (EELS in transmission electron microscopy (TEM)). This document outlines a method for quantitative measurement of defects in graphene at the nanoscale. The method specified in this document is applicable to single layer graphene acquired via chemical vapour deposition (CVD), roll-to-roll production and exfoliated graphene flakes to estimate the defect density. In order to obtain reliable data, it is essential that the procedure is consistent for each specified condition from the preparation of the TEM specimen to its observation. It is essential to maintain the spatial resolution below 1 nm by alignment of the beam. The dispersion value, which covers the entire energy loss near edge structure (ELNES) region of the carbon-K edge and maintains the highest energy resolution corresponds to 0,1 eV/ch. Defects in graphene are determined by measuring the spectral differences between sp2 hybridized and sp2/sp3 hybridized atoms, which are obtained by calculating the amplitude ratio of the π* and σ* orbital spectra.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • 300 mesh TEM grid

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TS 62607-6-33-2025 PDF

IEC TS 62607-6-33-2025 PDF

$163.93 $327.86