Photovoltaic (PV) modules – Test methods for the detection of potential-induced degradation – Part 1: Crystalline silicon
Introduction: This part of IEC TS 62804 is for testing and measuring the resistance of crystalline silicon photovoltaic (PV) modules to stresses that cause potential-induced degradation (PID). The applied stresses, mainly system voltage, manifest in different degradation mechanisms depending on the module technology. A series of Technical Specifications is therefore developed to establish tests for measuring PID in different photovoltaic module technologies. IEC TS 62804-1 defines test methods for measuring PID in crystalline silicon PV modules. IEC TS 62804-1-1 defines test methods for measuring PID delamination in crystalline silicon PV modules. IEC TS 62804-2 defines test methods for measuring PID in thin-film PV modules. Additional Technical Specifications in the series may be introduced in the future for emerging module technologies or related degradation modes. Voltage potential that exists between the active circuit and the grounded module surfaces can lead to module degradation by multiple mechanisms including ionic transport in the encapsulant, superstrate, or substrate, hot carriers in the cell, redistribution of charges that degrade the active layer of the cell or its surfaces, failure of adhesion at interfaces, and corrosion of module components. These degradation mechanisms in crystalline silicon photovoltaic modules caused by voltage stress and promoted by high temperature and humidity include potential-induced degradation, polarization, electrolytic corrosion, and electroche
Scope: This part of IEC 62804 defines procedures to evaluate the durability of crystalline silicon photovoltaic (PV) modules to the effects of short-term high-voltage stress, primarily potential- induced degradation (PID). Three test methods are given. The first type, which has two variations, is conducted in the dark and is primarily designed for assessing PID-shunting. The second type, which also has two variations, incorporates the factor of ultraviolet light and is intended for assessing PID-polarization. A separate test for the recovery of PID polarization under ultraviolet light is also included. The testing in this document is designed for crystalline silicon PV modules with silicon cells having passivating dielectric layers, for degradation mechanisms involving mobile ions influencing the electric field over the silicon semiconductor or electronically interacting with the silicon semiconductor. This document is not intended for evaluating modules with thin-film technologies, tandem, or heterojunction devices but can be used for guidance. The actual durability of modules to system voltage stress depends on the environmental conditions under which they are operated and the voltage potential in the module relative to earth (ground). These tests are intended to assess PV module sensitivity to PID irrespective of actual stresses under operation in different climates and systems.
Contents:
- FOREWORD
- INTRODUCTION
- Scope