Solar thermal electric plants – Part 3-3: Systems and components – General requirements and test methods for solar receivers
Introduction: The receiver is one of the most important and most sensitive components of Fresnel and parabolic trough power plants. Large mirrors are aligned to concentrate solar radiation up to 80 times along the focal line of the mirrors onto the specially coated, evacuated receivers. The generated heat is transported to a power generation unit, using a heat transfer fluid, and converted to electricity. The quality and long-term performance stability of the receiver has a decisive influence on how effectively solar radiation can be converted into heat. For the power plant to achieve maximum efficiency, the receiver has to absorb as much solar radiation as possible and convert it into heat with minimized losses. The solar receiver (see schematic in Figure 1) mainly consists of: a steel absorber tube: heat transfer fluid flows through the stainless-steel absorber tube. A high-quality absorber coating converts the solar radiation into heat and minimizes infrared heat loss at the same time; a glass cover tube: the cover is made from borosilicate glass and is coated with an antireflective film to increase solar transmittance; evacuated space (annulus) or filled with noble gas between absorber tube and glass cover tube: the vacuum between steel absorber and glass cover is essential to suppress gas heat convection; bellows: the bellows are necessary to compensate for different rates of heat expansion of the steel absorber and the glass cover. In contrast to the glass cover, the hot absorber exp
Scope: This document specifies the technical requirements, tests, durability and technical performance parameters of solar thermal receivers for absorbing concentrated solar radiation and transferring the heat to a fluid used in concentrated solar thermal power plants with linear-focus solar collectors. The receivers addressed consist of an absorber tube and an insulating glass envelope tube. NOTE 1 Most of the test methods included in this document apply to solar receivers used both in solar thermal electric plants with parabolic-trough and Fresnel collectors. This document includes the definitions of technical properties and characterization of geometry and performance parameters as well as the test methods for optical characterization, heat loss, and durability. NOTE 2 The experience accumulated so far regarding the different test methods currently available for receiver tubes is not extensive enough to determine which test method is the best; this document describes all the different methods currently available without defining one recommended method. For the sake of clarity, it is stated here that the thermal loss tests described in this document do not deliver the thermal loss of the receiver tubes when they are installed in commercial solar fields. Thermal losses obtained by indoor testing on a single receiver are significantly lower than the thermal losses in outdoor, real operating conditions at commercial solar fields. However, the indoor test procedures described in this document are suitable for receiver tube performance comparison. The thermal losses taken into account for solar field design are obtained by testing complete collectors operating under real solar conditions.
Contents:
- FOREWORD
- INTRODUCTION
- Scope