IEC TS 63109-2022 PDF

IEC TS 63109-2022 PDF

Photovoltaic (PV) modules and cells-Measurement of diode ideality factor by quantitative analysis of electroluminescence images

$132.41 $264.81 -50%
Product Code: IEC TS 63109
Stock In Stock
Edition: 1.0
Published: 03/2022
Number of Pages: 32
File Size: 1 file, 2 Bytes

Available Options

Product Description

Photovoltaic (PV) modules and cells – Measurement of diode ideality factor by quantitative analysis of electroluminescence images

Introduction: EL (Electroluminescence) diagnosis technique has been widely used for the evaluation of photovoltaic cells and modules photographically. EL images can identify various kinds of deficiencies, such as cracks and pin-holes in substrates, breakdown and detachment of electrodes, etc. In addition to these qualitative inspections, the quantitative analysis of EL intensity can reveal the electronic performance of photovoltaic cells [1] to [7]1. The EL intensity is proportional to the total number of minority carriers in photovoltaic cell bodies. The injection of minority carriers is governed by the I-V characteristics of pn junctions following the diode rectification formula, which yields that the EL intensity dependence upon the injection current will derive the diode ideality factor [8]. The proposed analysis method is not intended to give the criteria for the diagnosis of cells and modules, but the measured values of n are informative for stakeholders to share a common view about degradation phenomena among themselves. This standard measurement technique may be useful for the following stakeholders: a) Manufacturers ‒ checking validity of samples for both development and quality control (refer to Annex C). b) Power producers ‒ checking suspicious modules for potential failures (refer to Annex B). c) Reuse ‒ evaluation of value of second-hand modules (refer to Annex B). ____________ 1 Numbers in square brackets refer to the Bibliography.

Scope: This document specifies a method to measure the diode ideality factor of photovoltaic cells and modules by quantitative analysis of electroluminescence (EL) images. This document provides a definition of the term diode ideality factor n, as the inverse of increment ratio of natural logarithm of current as a function of applied voltage, which is related to the fill factor FF, and is useful as an effective indicator to represent the output efficiency of photovoltaic cells and modules with the other key parameters open circuit voltage Voc and short circuit current Isc. This document is only applicable to crystalline silicon photovoltaic cells and modules.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TS 63109-2022 PDF

IEC TS 63109-2022 PDF

$132.41 $264.81