IEEE C37.26-2014 PDF

IEEE C37.26-2014 PDF

IEEE Guide for Methods of Power-Factor Measurement for Low-Voltage (1000 V AC or lower) Inductive Test Circuits

$30.00 $60.00 -50%
isbn 9780738195834
Product Code: IEEE C37.26
Stock In Stock
Published: 10/03/2014
Number of Pages: 24
File Size: 1 file, 2.5 MB

Available Options

Product Description

IEEE Guide for Methods of Power-Factor Measurement for Low-Voltage (1000 V AC or lower) Inductive Test Circuits

Introduction: This introduction is not part of IEEE Std C37.26™-2014, IEEE Guide for Methods of Power-Factor Measurement for Low-Voltage (1000 V AC or lower) Inductive Test Circuits. This guide covers methods used to measure the power factor in low-voltage test circuits. Because the power- factor measurement for high-capacity test circuits is particularly difficult and different methods may yield different results, the methods that are least likely to yield error are recommended in this guide for any particular circuit condition. This low-voltage guide was originally created and issued in 1972 as a compatible companion to the high- voltage American National Standards Institute (ANSI) C37.05-1964 (R1969), American National Standard Methods for Determining the Values of a Sinusoidal Current Wave and a Normal-Frequency Recovery Voltage for AC High-Voltage Circuit Breakers, and ANSI C37.5-1969, American National Standard Methods for Determining Values of a Sinusoidal Current Wave, Normal-Frequency Recovery Voltage, and a Guide for Calculation of Fault Currents for Application of AC High-Voltage Circuit Breakers Rated on a Total Current Basis. The original guide served for many years, as use of the methods in this guide over several decades demonstrated the validity of the methods. It was revised in 2003 with few, if any, fundamental changes. This revision again makes only minor changes, as the underlying physics have not changed. Where possible, references have been changed to undated referenc

Contents:

  • 1.1 Scope
  • 1.2 Purpose
  • 1.3 Alternative methods
  • 4.1 General
  • 4.2 Procedures for determining the power factor
  • 5.1 General
  • 5.2 Procedure for determining the power factor
  • 6.1 General
  • 6.2 Procedure for determining the power factor

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEEE C37.26-2014 PDF

IEEE C37.26-2014 PDF

$30.00 $60.00