IEEE Standard for Standard Terminal Markings and Connections for Distribution and Power Transformers
Introduction: This introduction is not part of IEEE Std C57.12.70-2020, IEEE Standard for Standard Terminal Markings and Connections for Distribution and Power Transformers. In 1964, the first version of this standard was prepared. It replaced the material that originally appeared in a separate section of Part O of NEMA TR 1-1962, Transformers, Regulators, and Reactors. Moreover, it was intended that this standard would supersede the terminal markings and connections provided in ASA C6.1- 1956, Standard Terminal Markings for Electric Apparatus. After reaffirmation of this standard in 1971, it was revised and published as IEEE Std C57.12.70-1978. Significant revisions to this edition involved utilizing modern terminology, addition of zigzag phasor diagrams, inclusion of figures showing additional grounding connections, addition of figures showing “standard” and “reverse” arrangement commonly used in unit substations, and inclusion of a new “preferred” connection arrangement for three-phase delta-connected windings with a mid-tap in one winding. In 2000, the standard was again revised as IEEE Std C57.12.70-2000 (Reaff 2006). The primary intent of that revision was to update the standard to comply with the approved style of currently published standards, to update reference standards, and to add terminal markings for pad-mounted compartmental transformers. In 2011, the standard was again revised to update the references. Also an informative Annex A, Winding Connections Details and Explanation
Contents:
- 1.1 Scope
- 1.2 Purpose
- 1.3 Word usage
- 4.1 General
- 4.2 Sequence designation
- 4.3 External and Internal terminal designation
- 4.4 Neutral terminal designation
- 4.5 Grounded terminal designation
- 5.1 Types of transformers
- 5.2 Polarity
- 5.3 Order of numbering terminals of any winding
- 5.4 Order of numbering terminals of different windings
- 5.5 Location of H1 terminal
- 5.6 Parallel operation
- 7.1 Relation between highest voltage winding and other windings
- 7.2 Phase relationships and terminal markings
- 7.3 Marking of full winding terminals
- 7.4 Tap leads
- 7.5 Location of external terminals
- 7.6 Interphase connections made outside of case
- 7.7 Parallel operation
- 8.1 General
- 8.2 Marking of full winding terminals
- 8.3 Relation between three phase and six phase windings
- 8.4 Tap leads