IEEE Guide for the Application of Neutral Grounding in Electrical Utility Systems, Part III -Generator Auxiliary Systems
Introduction: This introduction is not part of IEEE Std C62.92.3-2012, IEEE Guide for the Application of Neutral Grounding in Electrical Utility Systems, Part III—Generator Auxiliary Systems. This guide is a part of a series of standards on neutral grounding in electrical utility systems. When the series was first approved and published, it replaced IEEE Std 143™-1954, IEEE Guide for Ground-Fault Neutralizers, Grounding of Synchronous Generator Systems, and Neutral Grounding of Transmission Systems. In this series of documents, individual considerations and practices have been given to the grounding of synchronous generator systems, generator-station auxiliary systems, and distribution systems. IEEE Std 143™-1954 is a revision of AIEE No. 954, October 1954, which was a compilation of the following three AIEE Transaction papers: AIEE Committee Guide Report, “Application of Ground-Fault Neutralizers,” AIEE Transactions (Power Apparatus and Systems), vol. 72, pt. III, pp. 183-190, April 1953. AIEE Committee Report, “Application Guide for the Grounding of Synchronous Generator Systems,” AIEE Transactions (Power Apparatus and Systems), vol. 72, pt. III, pp. 517-530, June 1953. AIEE Committee Report, “Application Guide on Methods of Neutral Grounding of Transmission Systems,” AIEE Transactions (Power Apparatus and Systems), vol. 72, pt. III, pp. 663-668, August, 1953. The contents of Part I through PartV of the revision of IEEE Std 143™-1954 are based on the foregoing documents but are amplified
Contents:
- 1.1 Scope
- 1.2 Purpose
- 4.1 Principal characteristics
- 4.2 Past and present practice
- 5.1 Basic factors
- 5.2 Service continuity
- 5.3 Damage criterion
- 5.4 Magnitude of overvoltages
- 5.5 Sensitivity and selectivity of ground-fault relaying
- 5.6 Magnitude of ground-fault current
- 5.7 Emergency, standby, vital, and safety-related ac and dc systems
- 6.1 Ungrounded
- 6.2 Resistance grounding
- 6.3 Effective grounding (solid or direct)
- 6.4 Grounding dc control systems
- 7.1 Grounding—general
- 7.2 Selection of a neutral grounding resistor