ISO 20299-1-2015 PDF

ISO 20299-1-2015 PDF

Film for wrapping rubber bales - Part 1: Butadiene rubber (BR) and styrenebutadiene rubber (SBR)

$31.50 $63.00 -50%
Product Code: ISO 20299-1
Stock In Stock
Edition: 2ND
Published: 09/15/2015
Number of Pages: 10
File Size: 1 file, 194 Bytes

Available Options

Product Description

Film for wrapping rubber bales - Part 1: Butadiene rubber (BR) and styrenebutadiene rubber (SBR)

Introduction: Considerable quantities of general-purpose synthetic rubber are prepared in crumb form. The crumbs are dried and then pressed into bales while still warm, at approximately 60 °C. The bales are then wrapped in a film and packed, often automatically, into crates. The wrapping film should be strong enough to withstand the stresses encountered during the wrapping and packaging operations. It should not adhere to the film on the other bales under the combined effects of the heat from the rubber and the weight of the bales. During storage, the rubber will flow and the film should be able to withstand the stresses generated. Any failure of the film will cause rubber-to- rubber adhesion, which in a 30-bale crate leads to a “one-tonne bale”. The prime purpose of the film is to keep the bales separate at all times so that they may be easily removed from their packaging for use. However, because it is difficult and uneconomic to strip the film from each bale, an essential feature is that the film should disperse in the rubber compound during mixing. This means that its melting point has to be lower than the temperatures attained in internal mixing cycles, typically 120 °C to 160 °C. Unfortunately, there is no acceptable or reproducible dispersal test available to measure this important property directly. Mixes carried out on a two-roll mill or in a single-stage internal mixer cycle might not reach the required temperature for dispersion. If this happens, then an option would be to strip

Scope: This part of ISO 20299 specifies the material and physical property requirements for non-strippable film for wrapping general-purpose synthetic rubber bales, intended to keep the bales separate during storage, for example for wrapping: — styrene-butadiene rubber (SBR); — butadiene rubber (BR). Certain applications or processing methods require the removal of the film. This part of ISO 20299 does not deal with strippable films.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 20299-1-2015 PDF

ISO 20299-1-2015 PDF

$31.50 $63.00