ISO 20304-4-2026 PDF

ISO 20304-4-2026 PDF

Fine bubble technology-Water treatment applications-Part 4: Test method for evaluating the antifouling performance of fine bubble water in crossflow membrane filtration systems

$145.50 $291.00 -50%
Product Code: ISO 20304-4
Stock In Stock
Edition: 1.
Published: 08/2026
Number of Pages: 62
File Size: 1 file, 8.5 MB

Available Options

Product Description

Fine bubble technology — Water treatment applications — Part 4: Test method for evaluating the antifouling performance of fine bubble water in crossflow membrane filtration systems

Introduction: Membrane separation processes exhibit high efficiency in removing various impurities from water. Hence, they have been widely employed for pure-water production, reclaimed-water treatment, and industrial wastewater treatment. However, the application of membrane separation technologies is limited by membrane fouling, which directly affects the economic feasibility and sustainability of these technologies. Conventional membrane antifouling techniques include introducing pre-filters, enhancing membrane hydrophilicity, applying surface coatings, and frequent physical and chemical cleaning. However, these approaches often lead to increased operational costs, environmental concerns, and limited effectiveness. In recent years, fine bubble (FB) and ultrafine bubble (UFB) technologies have been demonstrated to considerably reduce membrane fouling. However, there are currently no effective methods to evaluate the efficiency of these technologies for reducing membrane fouling. The silt density index (SDI), introduced by the American Society for Testing and Materials (ASTM), is a widely used standard for measuring the fouling potential caused by colloidal and suspended particles. However, the SDI has several limitations including a lack of temperature correction, insensitivity to membrane resistance variations, and poor correlation with colloidal or suspended particle concentrations. These shortcomings influence the accuracy and reproducibility, raising concerns about its predictive val

Scope: This document specifies a method for assessing the impact of ultrafine bubbles (UFBs) on membrane antifouling using the crossflow filtration system as the evaluation setup. The evaluation compares the membrane fouling behaviour of the original wastewater (control) with that of the same wastewater after UFB generation under specified operating conditions. This document is applicable to dispersions containing UFBs, including dispersions in which microbubbles (MBs) are present in combination with UFBs. The method employs the crossflow membrane fouling index (CMFI), measured under constant transmembrane pressure during crossflow filtration as the evaluation criterion. This method is applicable to various membrane treatment systems including ultrafiltration, nanofiltration, and reverse osmosis and can be used for different types of wastewater containing particulates, colloids, and soluble organic matter. This method is primarily intended for dispersions containing UFBs (see Annexes A to C and E); however, it is equally applicable, by analogy, to dispersions containing MBs (see Annex D). This document can guide the design and optimization of industrial processes that integrate FB technologies for enhanced membrane antifouling. NOTE 1 This method is intended for waters that contain a measurable amount of either particulate matter or colloidal matter, or both. It is not applicable to essentially particle-free waters, such as permeate from reverse osmosis or ultrafiltration systems. NOTE 2 Users can record supplementary information, e.g., turbidity, total suspended solids, and particle-size distribution; however, such data are not required in this document.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 20304-4-2026 PDF

ISO 20304-4-2026 PDF

$145.50 $291.00