ISO 20318-1-2019 PDF

ISO 20318-1-2019 PDF

Mechanical pencils and leads for general use-Classification, dimensions, quality and test methods-Part 1: Mechanical pencils

$48.00 $96.00 -50%
Product Code: ISO 20318-1
Stock In Stock
Edition: 1ST
Published: 02/2019
Number of Pages: 16
File Size: 1 file, 1 Byte

Available Options

Product Description

Mechanical pencils and leads for general use — Classification, dimensions, quality and test methods — Part 1: Mechanical pencils

Introduction: This document was developed in response to the recent increase in popularity of mechanical pencils and their leads among students who use them for general writing, and where varieties of both hardness degrees and thickness (designated as marking diameter) of leads have been expanding in response to different types of usage. It should be noted that the entire production volume of mechanical pencils has been increasing every year, whereas the production of mechanical pencils for technical drawings has been decreasing. Despite these recent trends, ISO 9177-1 was revised in 2011 with a scope limited to technical drawing usage only. Therefore, it is clear that this document is necessary for general use and that it should be independent of technical drawings. The ISO 20318 series consists of two parts: mechanical pencils and black leads. A set of a mechanical pencil and lead of the same marking diameter should be completely complementary, and should be compatible even with pencils and lead from different manufacturers. It should also be noted that there are two issues which have not been resolved since the first relevant standard was published. First, on marking of labelling the diameters on mechanical pencils and cases of leads, two designations coexist: 0,35 and 0,3 and 1 and 0,9. This document attempts to clarify this designation issue by defining diameters precisely. Second, a scientific definition of hardness degree of leads is not yet available. Even though this document trie

Scope: This document specifies classification, dimensions, quality and test methods for hand-held mechanical pencilss which hold and feed out a lead, and are used for general writing. It is also applicable to multi- function pens equipped with a mechanical pencil unit. However, those pencils attached to machinery instruments such as a plotter are excluded.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 20318-1-2019 PDF

ISO 20318-1-2019 PDF

$48.00 $96.00