ISO 10350-1-2025 PDF

ISO 10350-1-2025 PDF

Plastics-Acquisition and presentation of comparable single-point data-Part 1: Moulding materials

$60.00 $120.00 -50%
Product Code: ISO 10350-1
Stock In Stock
Edition: 4.
Published: 01/2025
Number of Pages: 18
File Size: 1 file, 2 Bytes

Available Options

Product Description

Plastiques - Acquisition et présentation de caractéristiques intrinsèques comparables - Partie 1: Matériaux pour moulage

Introduction: The ISO 10350 series identifies specific test procedures for the acquisition and presentation of comparable data for certain basic properties of plastics. In general, each property is specified by a single experimental value, although in certain cases properties are represented by two values obtained under different test conditions. The properties included are those presented conventionally in manufacturers' data sheets. NOTE ISO 10350-2 deals specifically with long- or continuous-fibre-reinforced plastics. For the purpose of this document, long-fibre-reinforced plastics are considered to have fibre length greater than 7,5 mm prior to moulding. The ISO 10350 series has been prepared because users of plastics find that available data cannot always be readily used to compare the properties of similar materials, especially when the data have been supplied by different sources. Even when the same standard tests have been used, they often allow the adoption of a wide range of alternative test conditions, and the data obtained are not necessarily comparable. The purpose of this document is to identify specific methods and conditions of test to be used for the acquisition and presentation of data in order that valid comparisons between materials can be made. The ISO 10350 series is concerned with tests employed to present “single-point” data on the limited range of properties commonly included in data sheets and used for the preliminary selection of materials. Such data represent th

Scope: This document defines test procedures for the acquisition and presentation of comparable data for moulding materials. This document applies predominantly to unreinforced and reinforced thermoplastic and thermosetting materials that can be injection- or compression-moulded or prepared as sheets of specified thickness.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 10350-1-2025 PDF

ISO 10350-1-2025 PDF

$60.00 $120.00