ISO 12051-2026 PDF

ISO 12051-2026 PDF

Plastics piping systems for water supply and drainage and sewerage under pressure-Modified poly(vinyl chloride)(PVC-M) pipe

$129.00 $258.00 -50%
Product Code: ISO 12051
Stock In Stock
Edition: 1.
Published: 09/2026
Number of Pages: 46
File Size: 1 file, 1.6 MB

Available Options

Product Description

Plastics piping systems for water supply and drainage and sewerage under pressure — Modified poly(vinyl chloride)(PVC-M) pipe

Introduction: This document defines the requirements for modified poly(vinyl chloride) (PVC-M) pipes. PVC-M pipe is similar in composition to unplasticized PVC (PVC-U) pipe except that an impact modifier has been added to alter the fracture mechanism, so that the material behaves in a more predictable, ductile manner. The combination of material formulation and processing conditions are such that the required strength and ductility is achieved. The more predictable, ductile fracture mechanism allows for reduced wall thickness with material and energy savings. It also results in improved resistance to crack propagation. Similar products have been specified in various national standards and have been referred to as PVC-A, PVC-HI, PVC-CPE, PVC-EPR and HIVP. This product is different to the product specified in the ISO 6993 series (PVC-HI). © ISO 2026 – All rights reserved

Scope: This document specifies requirements for pipe and integral joints of higher level of impact resistant PVC-M for the conveyance of water and waste water under pressure. The pipes are intended for installation below and above ground where they are not exposed to direct sunlight. This document also specifies the test parameters for the test methods in this document. This document is applicable to extruded PVC-M pipes without a socket and pipes with a socket (integral or not), intended to be used for the following purposes: a) water mains and services buried in the ground; b) conveyance of water above ground for both outside and inside buildings; c) buried and above-ground drainage and sewerage under pressure. This document is applicable to piping systems intended for the supply of water under pressure up to and including 25 °C (cold water) intended for human consumption and for general purposes as well as for waste water under pressure. This document specifies pipes for the conveyance of water and waste water up to and including 45 °C. For temperatures between 25 °C and 45 °C, Figure A.1 applies. NOTE 1 The producer and the end-user can come to agreement on the possibilities of use for temperatures above 45 °C on a case-by-case basis This document specifies a range of pipe sizes and pressure classes, and gives requirements concerning colours. NOTE 2 It is the responsibility of the purchaser or specifier to make the appropriate selections concerning pipe sizes, pressure classes and colours, taking into account their particular requirements and any relevant national regulations and installation practices or codes.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 12051-2026 PDF

ISO 12051-2026 PDF

$129.00 $258.00