Lubricants, industrial oils and related products (Class L) — Family C (gears) — Part 3: Specifications for greases for enclosed and open gear systems
Introduction: Lubricants for gear systems are used in diverse types of gear designs, ranging from simple parallel spur gears to bevel gears (straight or helical), worm gears and hypoid gears. Industrial gear systems, which are either of opened type or enclosed type, vary in size from small enclosed systems used in machine tools to very large systems used in mining, steel mills and cement plants. Lubricants for these applications vary in composition from refined straight mineral oils to more complex blends, based on mineral oils, synthetic oils (e.g. poly α-olefins, esters, poly-glycols) and additives friction modifying and/or extreme-pressure. Viscosity grades according to ISO 3448[5] vary, depending on the type of application and range, from the low viscosity ISO VG 32 to high viscosity ISO VG 1 500, even more for the very low velocities and very high loads. In exceptional cases, viscosity grades can be even higher. Temperature conditions to which the gear systems are exposed also vary considerably, not only due to the ambient conditions of operation, but also depending on the sliding between the gear teeth, on the size of the casings, on the presence on the circulating systems of heat exchangers, on the vicinity of sources of heat like in the cement industry or in the steel industry. Greases can also be used for the splash lubrication of enclosed gears or for the application on open gear teeth. © ISO 2021 – All rights reserved
Scope: This document establishes a classification and specifies the minimum requirements for mineral or synthetic base stock-based greases for the categories CKG and CKL according to ISO 6743-6 intended for the lubrication of enclosed and open gear systems. This document does not cover the extreme cases of use in terms of temperature and extreme charges conditions. For use in exceptional conditions, suppliers and purchasers of lubricants are intended to mutually agree on the testing methods and the acceptability criteria of the products, not covered by this document. NOTE 1 This document can be read in conjunction with ISO 6743-6, ISO 6743-9[1], ISO 12924[3] and ISO 6743-99[2]. NOTE 2 For the purpose of this document, the terms “% (m/m)” and “% (V/V)” are used to represent respectively the mass fraction and the volume fraction of a material.