ISO 132-2017 PDF

ISO 132-2017 PDF

Rubber, vulcanized or thermoplastic - Determination of flex cracking and crack growth (De Mattia)

$60.00 $120.00 -50%
Product Code: ISO 132
Stock In Stock
Edition: 6TH
Published: 07/2017
Number of Pages: 22
File Size: 1 file, 675 Bytes

Available Options

Product Description

Rubber, vulcanized or thermoplastic — Determination of flex cracking and crack growth (De Mattia)

Introduction: Repeated bending or flexing of a rubber causes cracks to develop in that part of the surface where tension stress is set up during flexing or, if this part of the surface contains a crack, causes this crack to extend in a direction perpendicular to the stress. Certain soft vulcanizates, for instance those prepared from styrene-butadiene rubber, show marked resistance to crack initiation, but it is possible for these vulcanizates to have a low resistance to growth (propagation) of cracks. It is important, therefore, to measure both the resistance to crack initiation by flexing and the resistance to crack propagation. The method is suitable for rubbers that have reasonably stable stress-strain properties, at least after a period of cycling, and do not show undue stress softening or set, or highly viscous behaviour. The results obtained for some thermoplastic rubbers should be treated with caution if the elongation at yield is below, or close to, the maximum strain imposed during the test. © ISO 2017 – All rights reserved

Scope: This document specifies a method of test intended for use in comparing the resistance of vulcanized or thermoplastic rubbers to the formation and growth of cracks, when subjected to repeated flexing on the De Mattia type machine. For determination of crack growth, an artificial cut is made in the test piece to initiate cut growth.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 132-2017 PDF

ISO 132-2017 PDF

$60.00 $120.00