ISO 13693-2-2015 PDF

ISO 13693-2-2015 PDF

Irrigation equipment - Safety devices for chemigation - Part 2: Chemigation valve assemblies from DN 75 (3”) to DN 350 (14”)

$48.00 $96.00 -50%
Product Code: ISO 13693-2
Stock In Stock
Edition: 1ST
Published: 02/15/2015
Number of Pages: 16
File Size: 1 file, 368 Bytes

Available Options

Product Description

Irrigation equipment - Safety devices for chemigation - Part 2: Chemigation valve assemblies from DN 75 (3”) to DN 350 (14”)

Introduction: Chemigation is the practice of injecting chemicals into irrigation water for the purpose of distributing the chemicals onto crops. During the course of this activity, under certain hydraulic conditions, the chemicals being injected can migrate upstream into a well or other pressurized water supply and pollute that water source. A chemigation valve assembly has been developed to meet this need. The chemigation valve assembly is designed to meet the specific need and performance requirements as required to prohibit the migration of injected chemicals into irrigation wells, thereby polluting ground water supplies. This part of ISO 13693 applies to a mainline check valve assembly in sizes from DN 75 (3”) to DN 350 (14”), with related components, that is designed to permit full flow in the operational mode and stop backflow (back siphonage or back pressure) when the pipeline shuts down. The potential for backflow from back siphonage occurs as water tumbles back down the column pipe when the pump shuts down. The potential for backflow occurs when a positive pressure exists on the downstream end of the valve. The valve obturator is forced to the closed position by a pre-tensioned spring. A resilient cover on the obturator helps to seal the valve against very low pressures. This chemigation valve assembly is included in a technical report (to be written) that specifies a complete chemigation safety system. This system features a chemical tank (fertilizers and chemicals), a chemical p

Scope: This part of ISO 13693 specifies the construction and performance requirement and test methods for metal-bodied chemigation valves with water at temperatures not exceeding 50 °C, which might contain fertilizers and chemicals of the types and concentration used in agriculture. The valve is designed to prohibit backflow caused by either back pressure or back siphonage. It is not designed for use in potable water systems. It is not to be confused with other forms of backflow prevention devices including pressure vacuum breakers, double check valves, reduced pressure zone valves, or goose neck loops. This part of ISO 13693 specifies the minimum design, construction, and performance testing requirements for the chemigation valve assembly. The assembly consists of the following components: — a valve body into which a spring-loaded check valve is mounted with a resilient disk cover on the sealing surface; — a combination air release/vacuum relief valve located upstream of the check valve; — a low pressure drain valve located upstream of the check valve; — an inspection port located so as to permit visual and manual inspection of the valve working components.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 13693-2-2015 PDF

ISO 13693-2-2015 PDF

$48.00 $96.00