Calculation method of carbon dioxide emission intensity from iron and steel production — Part 4: Guidance for using the ISO 14404 series
Introduction: The steel industry recognizes the urgent need to take actions concerning climate change. Slowing and halting global warming requires reductions in GHG emissions on a global scale. To play a part in achieving these reductions, it is necessary for steel plants to identify the amount of CO2 emitted during the production of steel products, in order to identify next opportunities for reduction of CO2. As the calculation methods for CO2 emission and intensity in iron and steel industry, ISO 14404-1 (for steel plants with blast furnace) and ISO 14404-2 (for steel plants with electric arc furnace) were published in 2013, and ISO 14404-3 (for steel plants with electric arc furnace and coal-based or gas- based direct reduction iron facility) was published in 2017. The ISO 14404 series specifies calculation methods for the carbon dioxide (CO2) intensity of a steel plant from the amounts of the major inputs (purchased items) and outputs (sold items), such as natural resources, intermediate products, and energy. The concept is shown in Figure 1. Figure 1 — Conceptual diagram of calculation method in the ISO 14404 series This calculation method only uses basic imports and exports that are commonly measured and recorded by the plants; thus, the method requires neither the measurement of the specific efficiency of individual equipment or processes nor dedicated measurements of the complex flow and recycling of materials and waste heat. In this way, the calculation method ensures its simplici
Scope: This document provides guidance for calculating the CO2 intensity at steel plants with all types of process routes, by defining the boundary, CO2 emission factors and the intermediate products for which upstream emissions are considered for all types of process routes. In particular, this document provides guidance applicable to the ISO 14404 series to the types of steel plants listed below. This document also includes the Universal Calculation Sheet, which covers all relevant emission sources from ISO 14404-1, ISO 14404-2 and ISO 14404-3 to assist the calculation of CO2 emissions. i. Steel plants with different process routes from ISO 14404-1, ISO 14404-2 and ISO 14404-3 (7.2.1) ii. Steel plants with more than one process route (7.2.2) iii. Steel plants purchasing pig iron from the outside (7.2.3) iv. Steel plants and rerollers purchasing part or all of crude steel from outside (7.2.4) Moreover, this document provides additional guidance to the entire ISO 14404 series for the following topics. a) Evaluation of exported slags b) Evaluation of by-product gas c) Evaluation of stock d) Selection of calorific values and emission factors for electricity and fuel Conversion to energy consumption and to consumption efficiency can be obtained using Annex A. While the use of the calculation result is outside the scope of this document, appropriate applications and inappropriate application are recommended in Annex B.