ISO 14728-2-2017 PDF

ISO 14728-2-2017 PDF

Rolling bearings - Linear motion rolling bearings - Part 2: Static load ratings

$48.00 $96.00 -50%
Product Code: ISO 14728-2
Stock In Stock
Edition: 2ND
Published: 02/2017
Number of Pages: 18
File Size: 1 file, 561 Bytes

Available Options

Product Description

Rolling bearings - Linear motion rolling bearings - Part 2: Static load ratings

Introduction: It is often impractical to establish the suitability of a linear motion rolling bearing selected for a specific application by testing. The following procedures have proved to be an appropriate and convenient substitute for testing: — life calculation with dynamic load (ISO 14728-1); — static load safety factor calculation with static load (ISO 14728-2). Permanent deformation appears in rolling elements and raceways of rolling bearings under static loads of moderate magnitude and increases gradually with increasing load. It is often impractical to establish whether the deformation appearing in a bearing in a specific application is permissible by testing the bearing in that application. Other methods are therefore required to establish the suitability of the bearing selected. Experience shows that a total permanent deformation of 0,000 1 of the rolling element diameter, at the centre of the most heavily loaded rolling element/raceway contact, can be tolerated in most bearing applications without the subsequent bearing operation being impaired. The basic static load rating is, therefore, given a magnitude such that approximately that degree of deformation occurs when the static equivalent load is equal to the load rating. Tests in different countries indicate that a load of the magnitude in question may be considered to correspond to a calculated contact stress of — 5 300 MPa for recirculating linear ball bearings, sleeve type, — 4 200 MPa to 4 600 MPa for recirculating linear

Scope: This document specifies methods of calculating the basic static load rating, static equivalent load and static safety factor for linear motion rolling bearings manufactured from contemporary, commonly used, high quality, hardened bearing steel in accordance with good manufacturing practice and basically of conventional design with regard to the shape of the rolling contact surfaces. This document is not applicable to designs where the rolling elements operate directly on the slide surface of the machine equipment, unless that surface is equivalent in all respects to the raceway of the linear motion rolling bearing component it replaces.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 14728-2-2017 PDF

ISO 14728-2-2017 PDF

$48.00 $96.00