ISO 14912-2025 PDF

ISO 14912-2025 PDF

Gas analysis-Conversion of gas mixture composition data

$145.50 $291.00 -50%
Product Code: ISO 14912
Stock In Stock
Edition: 2.
Published: 05/2025
Number of Pages: 62
File Size: 1 file, 3 Bytes

Available Options

Product Description

Gas analysis — Conversion of gas mixture composition data

Introduction: The composition of a gas mixture is given by the identity of the mixture components and their content in the mixture. For the purpose of expressing component contents, different quantities are in use, the most common ones being mass concentration, amount fraction and volume fraction. This diversity is due to the fact that in different applications, different quantities have decisive advantages. Therefore, procedures for conversion between different quantities are needed. As far as these quantities involve volumes, their value depends on the state conditions, i.e., pressure and temperature, of the gas mixture. For these quantities, therefore, procedures for conversion between different state conditions are needed. As a crude approximation, all of the conversions referred to above can be performed on the basis of the ideal gas law. In most cases, however, an accurate conversion shall take into account the real gas behaviour of the components and of the entire gas mixture. These calculations use values of the compression factor (or the density) of the components concerned and the entire gas mixture. This document provides conversion procedures which fully account for real gas behaviour of pure gases and gas mixtures. In addition to these, approximate procedures for practical applications are described, designed for different levels of accuracy and available data. These procedures are based on approximate calculations of a) pure gas compression factors using virial coefficients a

Scope: This document defines the following quantities commonly used to express the composition of gas mixtures: — amount fraction and concentration; — mass fraction and concentration; — volume fraction and concentration. For these quantities of composition, this document specifies methods for: — conversion between different quantities; — conversion between different state conditions. Conversion between different quantities means calculating the value of the content of a specified component in terms of one of the quantities listed above from the value of the same content, at the same pressure and temperature of the gas mixture, given in terms of another of these quantities. Conversion between different state conditions means calculating the value of the content of a specified component, in terms of one of the quantities listed above, under one set of state conditions from the value of the same quantity under another set of state conditions, i.e., pressure and temperature, of the gas mixture. Gas mixture composition can be converted simultaneously between different quantities of composition and different state conditions by combination of the two types of conversion. This document is applicable only to homogeneous and stable gas mixtures. Therefore, any state conditions (pressure and temperature) considered need to be well outside the condensation region of the gas mixture. In addition, volume concentrations can only be used if the component under consideration is completely gaseous, and for the use of volume fractions, all components need to be completely gaseous. Further restrictions of state conditions apply for approximations of compression factors using virial coefficients (see Annex A).

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 14912-2025 PDF

ISO 14912-2025 PDF

$145.50 $291.00