Plastics piping systems for hot and cold water installations — Crosslinked polyethylene (PE-X) — Part 3: Fittings
Introduction: The ISO 15875 series specifies the requirements for a piping system consisting of pipe, fitting and the jointing made of it, when the pipe is made from crosslinked polyethylene (PE-X). The ISO 15875 series consists of ISO 15875-1, ISO 15875-2, ISO 15875-2 and ISO 15875-5, and covers the requirements and related test methods for all components used in the system (e. g. pipes and fittings). In addition, the ISO 15875 series includes requirements and related test methods to verify the performance and compatibility of the jointing of components. The piping system is intended to be used for hot and cold water installations. In respect of potential adverse effects on the quality of water intended for human consumption, caused by the product covered by the ISO 15875 series: — the ISO 15875 series provides no information as to whether the product may be used without restriction in any of the Member States of the EU or EFTA; — it should be noted that, while awaiting the adoption of verifiable European criteria, existing national regulations concerning the use and/or the characteristics of this product remain in force. Requirements and test methods for materials and components, other than fittings, are specified in ISO 15875-1 and ISO 15875-2. Characteristics for fitness for purpose (mainly for joints) are covered in ISO 15875-5. ISO/TS 15875-7 gives guidance for the assessment of conformity. This document specifies the characteristics of the fittings. At the date of publication of thi
Scope: This document specifies the characteristics of fittings for crosslinked polyethylene (PE-X) piping systems intended to be used for hot and cold water installations within buildings for the conveyance of water, whether or not intended for human consumption (domestic systems) and for heating systems under design pressures and temperatures according to the class of application (see ISO 15875-1:—, Table 1). This document also specifies the test parameters for the test methods referred to herein. This document is applicable to fittings made from PE-X or other plastics or non-plastics materials, which are intended to be connected to pipes conforming to ISO 15875-2 for hot and cold water installations, whereby the joints conform to the requirements of ISO 15875-5. This document is applicable to fittings of the following types: — mechanical fittings; — electrofusion fittings;