ISO 16422-1-2024 PDF

ISO 16422-1-2024 PDF

Pipes and joints made of oriented unplasticized poly(vinyl chloride) (PVC-O) for the conveyance of water under pressure-Part 1: General

$48.00 $96.00 -50%
Product Code: ISO 16422-1
Stock In Stock
Edition: 1.
Published: 02/2024
Number of Pages: 16
File Size: 1 file, 2 Bytes

Available Options

Product Description

Pipes and joints made of oriented unplasticized poly(vinyl chloride) (PVC-O) for the conveyance of water under pressure — Part 1: General

Introduction: Molecular orientation of thermoplastics results in the improvement of physical and mechanical properties. Orientation is carried out at temperatures well above the glass transition temperature. Orientation of PVC-U pipe-material can be induced by different processes. In general, the following production process is common. — A thick-wall tube is extruded (feedstock) and conditioned at the desired temperature. — The orientation process is activated primarily in circumferential direction under controlled conditions. Axial orientation can also be activated in the product. — After the orientation process, the pipe is cooled down quickly to ambient temperature. The orientation of the molecules creates a laminar structure in the material of the pipe wall. This structure gives the ability to withstand brittle failure emanating from minor flaws in the material matrix or from scratches at the surface of the pipe wall. Improved hoop strength allows reduced wall thickness with material and energy savings. It also results in improved resistance to impact and fatigue. The classification of the material depends on material compound/formulation and stretch ratios used. Therefore, with the classification, these characteristics may be specified or determined. Regarding potential adverse effects on the quality of water intended for human consumption caused by the products covered by this document, this document provides no information as to whether or not the products can be used without restri

Scope: This document specifies the general characteristics of solid-wall pipes made of oriented unplasticized poly(vinyl chloride) (PVC-O) for piping systems intended to be used underground or above-ground (where protected from direct sunlight), for water supply, buried drainage, sewerage, treated waste water and irrigation under pressure. In conjunction with ISO 16422-2, ISO/TS 16422-3, ISO 16422-5 and ISO 1452-4, this document is applicable to PVC-O pipes and PVC-O fittings, as well as to valves, their joints and to joints with components of other plastics and non-plastics materials intended to be used for the following: a) water mains and services lines; b) conveyance of water for both outside and inside buildings; c) drainage, sewerage and treated wastewater under pressure; d) irrigation under pressure. This document is applicable to piping systems intended for the supply of water under pressure up to and including 25 °C (cold water), intended for human consumption and for general purposes as well as for wastewater under pressure. This document is also applicable to components for the conveyance of water and wastewater up to and including 45 °C. For temperatures between 25 °C and 45 °C, see ISO 16422-2:2023, Figure C.1. The piping system according to this document is intended for the conveyance of cold water up to pressures of 25 bar1) and especially in those applications where special performance requirements are needed, such as impact loads and pressure fluctuations, up to pressure of 25 bar.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 16422-1-2024 PDF

ISO 16422-1-2024 PDF

$48.00 $96.00