ISO 17208-3-2025 PDF

ISO 17208-3-2025 PDF

Underwater acoustics-Quantities and procedures for description and measurement of underwater sound from ships-Part 3: Requirements for measurements in shallow water

$145.50 $291.00 -50%
Product Code: ISO 17208-3
Stock In Stock
Edition: 1.
Published: 09/2025
Number of Pages: 66
File Size: 1 file, 6 Bytes

Available Options

Product Description

Underwater acoustics — Quantities and procedures for description and measurement of underwater sound from ships — Part 3: Requirements for measurements in shallow water

Introduction: The ISO 17208 series describe procedures for the measurement and analysis of underwater sound from ships. The methodology and measurement configuration are sufficient to provide reliable acoustic data, but also suitable for end-users to conduct the measurements without access to large, fixed sound measurement facilities. ISO17208-1 covers measurements of radiated noise level in deep water, and ISO 17208-2 the calculation of source level from the deep-water data. This document has been developed to address the need to cover source level measurements in shallow water, one reason being that deep water maritime areas are sometimes far away from the zone of operation of the ships considered. The development of this document was supported by the EU-funded Horizon 2020 research programme SATURN (Developing solutions to underwater radiated noise)1) and by the MMP2 project2), sponsored by Transport Canada’s Innovation Centre. 1) https://doi.org/10.3030/101006443 2) https://doi.org/10.1121/10.0017433 © ISO 2025 – All rights reserved

Scope: ISO 17208 series describe procedures for the measurement of underwater sound radiated by the ship under test, and for calculating sound source quantities such as source level and radiated noise level from the measurement results. In ISO 17208-1 to ISO 17208-3 it is presumed that the ship under test cooperates in the measurements, sailing multiple runs over a specified track past the measurement system at a specified speed with pre- determined machinery configurations. Opportunistic measurements of the radiated sound of passing ships are outside the scope of these three standards. Part 1 of the ISO 17208 standards[1] provides the procedure to quantify the underwater sound from the ship in terms of its radiated noise level, which is calculated from the sound pressure level (SPL) measured in the far field of the ship, in beam aspect, scaled by the distance to CPA and reported in decidecade bands. The intended use of radiated noise level is to show compliance with contract requirements or criteria, for comparison of one ship to another ship, to enable periodic signature assessments, and for research and development. ISO 17208-2[1] specifies methods for calculating the source level of an equivalent monopole source at a specified nominal source depth from the radiated noise level values obtained according to ISO 17208-1. The intended use of source level, with associated nominal source depth, is to perform far field sound predictions such as needed for environmental impact studies or for creating underwater sound contour maps. ISO 17208-1 and ISO 17208-2[1] are applicable for measurements in deep water, defined as water depth greater than the larger of 150 m and 1,5 times overall ship length. The allowable water depths and environmental conditions for part 3 measurements are described in 4.5. This document specifies procedures for the measurement of underwater sound radiated by the ship under test in shallow water. It also specifies procedures for the calculation of source level, with associated nominal source depth, from the sound pressure measurements, accounting for the relevant phenomena that govern the propagation of sound in shallow water. These calculations are

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 17208-3-2025 PDF

ISO 17208-3-2025 PDF

$145.50 $291.00