Ships and marine technology — Design and testing requirements of pneumatic quick-closing valves
Introduction: Marine pneumatic quick-closing valves are extremely important for the prevention of fires caused by flammable liquids and the overall safety programme onboard ships. According to SOLAS Chapter II-2 Regulation 4,[16] in the event of a fire, the following must be fitted with a cock or valve directly on the tank, which can be closed from a safe position outside the space concerned: a) oil fuel pipes, which, if damaged, would allow oil to escape from a storage; b) settling or daily service tank having a capacity of 500 l and above, situated above the double bottom. In older ships, the valve would normally be closed manually through a long mechanical connection from the valve to the position outside the machinery space. In modern ships, this valve is usually a pneumatic quick- closing valve (PQCV), which uses compressed air and spring tension to rapidly close off the fuel or oil flow in the event of a leak downstream of the tank. The PQCV is operated by a pneumatic quick-closing control devices, the specifications of which are defined by ISO 24225. Proper operation of pneumatic quick-closing valves is one of the most important items to be checked during port state supervision ship inspections. If the quick-closing valve operation fails, the port state will likely require the problem to be corrected before the ship can proceed. This can result in detention of the ship, with adverse effects on the ship’s schedule. Therefore, it is important to develop standards specifying the design
Scope: This document specifies requirements for the design and tests of pneumatic driven quick-closing valves, used in ship fuel and lubricating oil systems to stop the fluid flow in the event of a leak. This document is applicable to valves of nominal diameter (DN): 15, 20, 25, 32, 40, 50, 65, 80, 100, 125, 150, 200, 250, and 300, corresponding to nominal pipe sizes (NPS): 1/2, 3/4, 1, 1 1/4, 1 1/2, 2, 2 1/2, 3, 4, 5, 6, 8, 10, and 12. NOTE This document is mainly intended for use by producers. Onboard ship inspection and maintenance after the delivery and installation of the valve can help ensure continued proper performance.