ISO 17607-1-2023 PDF

ISO 17607-1-2023 PDF

Steel structures-Execution of structural steelwork-Part 1: General requirements and terms and definitions

$113.50 $227.00 -50%
Product Code: ISO 17607-1
Stock In Stock
Edition: 1.
Published: 12/2023
Number of Pages: 40
File Size: 1 file, 2 Bytes

Available Options

Product Description

Steel structures — Execution of structural steelwork — Part 1: General requirements and terms and definitions

Introduction: Specific requirements for the achievement of structures that are optimal with respect to safety, the state of the economy, development and general values of a nation are given in the appropriate regional or national standards, if they exist. Many nations do not have their own standards for structural steelwork. Some refer to other national or regional standards. Some permit the project’s standard to be selected by the owner, designer or constructor of the structure. Some do not require any standards to be followed. The ISO 17607 series of standards on the execution of structural steelwork was developed to serve as a means to provide a set of requirements and guidance for projects that are constructed without a governing regional or national standard. The ISO 17607 series can also serve to reduce trade barriers. Additional requirements to be addressed in the execution of structural steelwork, as structures or as fabricated components, can be found in the other parts of the series: — ISO 17607-2 (Steels); — ISO 17607-3 (Fabrication); — ISO 17607-4 (Erection); — ISO 17607-5 (Welding); — ISO 17607-6 (Bolting). © ISO 2023 – All rights reserved

Scope: This document defines general requirements for the execution of structural steelwork for: — structural steel buildings; — general structures, designed, fabricated, and erected in a manner similar to buildings with building- like load-resisting elements, e.g. support framing for equipment, tanks, vessels, and pipelines; — crane-supporting structures; — typical roadway and pedestrian bridges including those constructed using rolled sections, welded plate girders, or trusses (lattices). This document applies to structures or fabricated components that are produced from: — hot-rolled and cold-formed structural steel products up to and including a nominal yield strength of 700 MPa with a thickness of 3 mm and above; — hot-finished and cold-formed structural steel hollow sections, up to and including a nominal yield strength of 700 MPa, including standard range and custom-made rolled products and hollow sections manufactured by welding. This document also applies to steel components in composite steel and concrete structures, and in structures combining steel with other materials. This document defines requirements independent of the type and shape of the steel structure, including structures subjected to fatigue or seismic loading. The requirements are expressed in terms of execution levels. This document does not define all requirements for other types of fabricated steel structures (e.g. railway bridges, roadway and pedestrian bridges using welded box sections or arch boxes, cable- supported bridges over 100 m span, moving bridges, monorails, steel towers, masts, chimneys, silos, tanks, pipelines, antennae, offshore platforms). However, this document provides general guidance regarding fabrication and erection practices that may be used together with the appropriate ISO, regional or national design standards for such structures. This document does not cover requirements for the following: — sheeting; — fabrication of stainless steels. This document does not apply to design of steel structures. NOTE Design is inextricably a part of the design-fabrication-erection sequence, including the application of tolerances, and cannot be considered in isolation. This document

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 17607-1-2023 PDF

ISO 17607-1-2023 PDF

$113.50 $227.00