Particle size analysis — Small angle X-ray scattering (SAXS)
Introduction: This document deals with small-angle X-ray scattering (SAXS), which is performed for particle size analysis in the 1 nm to 100 nm size range. Under certain conditions (narrow size distributions, appropriate instrumental configuration, and idealised shape) the limit of 100 nm can be significantly extended. In ideal circumstances, SAXS can determine the mean particle diameter and particle size distribution, surface area, and sometimes particle shape in a reasonably rapid measurement time. User- friendly commercial instruments are available worldwide from a number of manufacturers for both routine and more sophisticated analyses, and state-of-the-art research instruments are available at synchrotron radiation facilities. As in all particle size measurement techniques, care is required in all aspects of the use of the instrument, collection of data, and further interpretation. Therefore, there is a need for an International Standard that allows users to obtain good interlaboratory agreement on the accuracy and reproducibility of the technique. SAXS can be applied to any hetero-phase system, in which the two or more phases have a different electron density. In most cases, the electron density corresponds reasonably well to the mass density. SAXS is sensitive to the squared electron density difference. For fixed volume fractions, it does not matter whether the particles constitute the denser phase and the solvent (or matrix) is the less-dense phase or vice versa. Thus, pore size di
Scope: This document specifies a method for the application of small-angle X-ray scattering (SAXS) to the estimation of mean particle sizes in the 1 nm to 100 nm size range. It is applicable in dilute dispersions where the interaction and scattering effects between the particles are negligible. This document describes several data evaluation methods: the Guinier approximation, model-based data fitting, Monte- Carlo–based data fitting, the indirect Fourier transform method and the expectation maximization method. The most appropriate evaluation method is intended to be selected by the analyst and stated clearly in the report. While the Guinier approximation only provides an estimate for the mean particle diameter, the other methods also give insight in the particle size distribution.