Road vehicles — Local Interconnect Network (LIN) — Part 8: Electrical physical layer (EPL) specification: LIN over DC powerline (DC-LIN)
Introduction: ISO 17987 (all parts) specifies the use cases, communication protocol and physical layer requirements of an in-vehicle communication network called Local Interconnect Network (LIN). The LIN protocol as proposed is an automotive-focused low speed UART-based network (Universal Asynchronous Receiver Transmitter). Some of the key characteristics of the LIN protocol are signal- based communication, schedule table-based frame transfer, master/slave communication with error detection, node configuration and diagnostic service transportation. The LIN protocol is for low cost automotive control applications, for example door module and air conditioning systems. It serves as a communication infrastructure for low-speed control applications in vehicles by providing: — signal-based communication to exchange information between applications in different nodes; — bit rate support from 1 kbit/s to 20 kbit/s; — deterministic schedule table-based frame communication; — network management that wakes up and puts the LIN cluster into sleep mode in a controlled manner; — status management that provides error handling and error signalling; — transport layer that allows large amount of data to be transported (such as diagnostic services); — specification of how to handle diagnostic services; — electrical physical layer specifications; — node description language describing properties of slave nodes; — network description file describing behaviour of communication; — application programmer's interfa
Scope: This document specifies an additional electrical physical layer (EPL) for the Local Interconnect Network (LIN) of the ISO 17987 series. It specifies the transmission over DC powerline without affecting the LIN higher layers, hereafter named DC-LIN. The DC-LIN EPL uses a high-frequency modulated carrier to propagate UART bytes (byte-oriented) over the DC powerline. This document specifies the electrical characteristics, the modulation method of the transmission, and how to impose the carrier signal on the DC powerlines. The DC-LIN EPL supports bit rates of 9 615 bit/s, 10 417 bit/s, and 19 230 bit/s. The DC-LIN EPL is applicable for a wide range of DC powerlines including 12-V and 24-V operations, allowing communicating between different DC powerlines via a coupling capacitor. A DC-LIN EPL interface to powerline example is described in Annex A.