Caoutchouc vulcanisé ou thermoplastique - Détermination de l’action des liquides
Introduction: The action of a liquid on vulcanized or thermoplastic rubber can generally result in: a) absorption of the liquid by the rubber; b) extraction of soluble constituents from the rubber; c) a chemical reaction with the rubber. The amount of absorption [a)] is usually larger than that of extraction [b)], so that the net result is an increase in volume, commonly termed “swelling”. The absorption of liquid can profoundly alter physical and chemical properties and hence change tensile strength, extensibility and hardness of the rubber, so it is important to measure these properties after treatment of the rubber. The extraction of soluble constituents, especially plasticizers and antidegradants can likewise alter the rubber's physical properties and chemical resistance after drying (assuming the liquid to be volatile). Therefore, it is necessary to test these properties following immersion and drying of the rubber. This document describes the methods necessary for determining the following properties after immersion and after immersion and drying: — change in mass, volume and dimensions; — extractable matter; — change in hardness and tensile stress-strain properties. Although in some respects these tests can simulate service conditions, no direct correlation with service behaviour is implied. Thus, the rubber giving the lowest change in volume is not necessarily the best one in service. The thickness of the rubber must be taken into account, since the rate of penetration of liquid is
Scope: This document describes methods of evaluating the resistance of vulcanized and thermoplastic rubbers to the action of liquids by measurement of properties of the rubbers before and after immersion in test liquids. The liquids concerned include current service liquids, such as petroleum derivatives, organic solvents and chemical reagents, as well as reference test liquids.