Environmental solid matrices — Determination of elemental composition by X-ray fluorescence spectrometry
Introduction: X-ray fluorescence (XRF) spectrometry is a fast and reliable method for the quantitative analysis of the total content of certain elements within different matrices. The quality of the results obtained depends very closely on the type of instrument used, e.g. bench top or high performance, energy dispersive or wavelength dispersive instruments. When selecting a specific instrument several factors should be considered, such as the matrices to be analysed, elements to be determined, detection limits required and the measuring time. The quality of the results depends on the element to be determined and on the surrounding matrix. Due to the wide range of matrix compositions and the lack of suitable reference materials in the case of inhomogeneous matrices such as waste, it is generally difficult to set up a calibration with matrix- matched reference materials. Therefore, this document describes two different procedures: — a quantitative analytical procedure required for homogeneous solid waste, soil and soil-like material, where the calibration is based on matrix-matched standards; — an optional XRF screening method for solid and liquid material as waste, sludge and soil in Annex A which provides a total element characterization at a semi-quantitative level, where the calibration is based on matrix-independent calibration curves, previously set up by the manufacturer. © ISO 2025 – All rights reserved
Scope: This document specifies the procedure for a quantitative determination of major and trace element concentrations in homogeneous solid waste, soil, soil-like material and sludge by energy dispersive X-ray fluorescence (EDXRF) spectrometry or wavelength dispersive X-ray fluorescence (WDXRF) spectrometry using a calibration with matrix-matched standards. This document is applicable for the following elements: Na, Mg, Al, Si, P, S, Cl, K, Ca, Ti, V, Cr, Mn, Fe, Co, Ni, Cu, Zn, As, Se, Br, Rb, Sr, Y, Zr, Nb, Mo, Ag, Cd, Sn, Sb, Te, I, Cs, Ba, Ta, W, Hg, Tl, Pb, Bi, Th and U. Concentration levels between a mass fraction of approximately 0,000 1 % and 100 % can be determined depending on the element and the instrument used. An optional XRF screening method for solid and liquid material as waste, sludge and soil is added in Annex A which provides a total element characterization at a semi-quantitative level, where the calibration is based on matrix-independent calibration curves, previously set up by the manufacturer.