Simplified design of prestressed concrete tanks for potable water
Introduction: The aim of this document is to provide rules for the design and construction of prestressed concrete water tanks to be built in less-developed areas of the world. The design rules are based on simplified worldwide- accepted strength models. This document is self-contained; therefore actions (loads) and simplified analysis procedures are included, as well as minimum acceptable construction practice guidelines. A great effort was made to include self-explanatory tables, graphics and design aids to simplify the use of this document and provide procedures. Notwithstanding, the economic implications of the conservatism inherent in approximate procedures as a substitution to sound and experienced engineering should be a matter of concern to the designer who employs this document and to the owner who hires him. A prestressed concrete tank for potable water generally comprises the roof, wall and base slab. The roof is made to entirely cover the top of the cylindrical wall to protect the water from contamination with rainwater, etc. In many cases, it is made in the form of a dome shaped like a convex circular plate cut off from a sphere. The wall is a vertical cylinder that forms a container for water in combination with the flat base slab. Only the wall of a prestressed concrete water tank is made with prestressed concrete, while the roof and base slab are made with reinforced concrete. Prestress is generally applied to the wall using prestressing steel in the vertical and circumfere
Scope: This document provides guidelines for the planning, design and construction of a cylindrical tank constructed on the ground with prestressed concrete (PC) for use with potable water tank. This document is applicable to PC tanks for potable water with a capacity of 30 000 m3 or less and the diameter-to-height ratio (D/H) from 1,0 to 3,0. NOTE 1 The D/H ratio within the range of 1 to 3 is generally considered as a reasonable shape for a PC water tank. However, even if the ratio exceeds 3, this document is applied for design purposes except for applying the Hausner method. NOTE 2 When designing and constructing a tank not covered by this document (reinforced concrete tanks, underground tanks, elevated tanks, etc.), a designer can refer to this document for common elements where possible.