Petroleum and natural gas industry — Pipeline transportation systems — Pipeline integrity management specification — Part 2: Full-life cycle integrity management for offshore pipeline
Introduction: This document addresses the integrity of petroleum and natural gas pipelines through their entire life-cycle, from design to eventual abandonment. For this reason, considerations relating to design, construction and abandonment have been included. This approach supports the development and implementation of a holistic and integrated pipeline integrity management program that bridges between life-cycle elements and thereby avoids compartmentalizing of the pipeline life-cycle into essentially independent data and functional silos, which has traditionally been the case. The integrated approach was developed on the basis of extensive research and examination of best practices and results from pipeline integrity audits world-wide. This document is intended to be used by companies that have not yet developed an official program or are developing a program for new pipelines. This document can also be used to guide continual improvement of existing programs by both operating companies and regulators to evaluate integrity management program effectiveness. viii © ISO 2019 – All rights reserved
Scope: This document specifies requirements and gives recommendations on the management of integrity of a pipeline system throughout its life cycle, which includes design, construction, commissioning, operation, maintenance and abandonment. This document is applicable to offshore pipelines for transporting petroleum and natural gas. It is applicable to rigid steel pipelines. It is not applicable to flexible pipelines, dynamic risers or those constructed from other materials, such as glass-reinforced plastics. NOTE 1 An offshore pipeline system extends to: the first valve, flange or connection above water on platform or subsea mechanical connector with subsea structure (i.e. manifold or dynamic riser); the connection point to the offshore installation (i.e. piping manifolds are not included); the first valve, flange, connection or isolation joint at a landfall, unless otherwise specified by the onshore legislation. NOTE 2 The components mentioned above (valve, flange, connection, isolation joint) include also any pup pieces, i.e. the offshore pipeline system extends to the weld beyond the pup piece, see Figure 1. This document is used for integrity management, which is initiated at the design and construction stage of the pipeline. Where requirements of a design and construction standard (e.g. ISO 13623) are different, the provisions of this document will enhance the design and construction from an integrity perspective. INTERNATIONAL STANDARD ISO 19345-2:2019(E) © ISO 2019 – All rights reserved ISO 19345-2:2019(E) Key first valve, flange, connection or isolation joint nearshore section connector point to subsea piping shore approach topside offshore section pipeline system onshore section pipeline subsea structure covered by this document first valve, flange, connection or isolation joint not covered by this document Figure 1 — Extent of pipeline systems covered by this document 2 © ISO 2019 – All rights reserved