ISO 19905-4-2026 PDF

ISO 19905-4-2026 PDF

Site-specific assessment of mobile offshore units-Part 4: Jack-up installation and removal at a site

$162.00 $324.00 -50%
Product Code: ISO 19905-4
Stock In Stock
Edition: 1.
Published: 08/2026
Number of Pages: 104
File Size: 1 file, 5.4 MB

Available Options

Product Description

Site-specific assessment of mobile offshore units — Part 4: Jack-up installation and removal at a site

Introduction: The International Standards on offshore structures prepared by TC 67/SC 7 [i.e. ISO 19900, ISO 19901 (all parts), ISO 19902, ISO 19903, ISO 19904-1, ISO 19905 (all parts) and ISO 19906] constitute a common basis covering those aspects that address design requirements and assessments of all offshore structures used in the energy sector worldwide. Through their application, the intention is to achieve reliability levels appropriate for offshore structures, whatever the type of structure and the nature of the materials used. Structural integrity is an overall concept comprising models for describing actions, structural analyses, design or assessment rules, safety elements, quality of work, quality control procedures and national requirements, all of which are mutually dependent. The modification of one aspect of design or assessment in isolation can disturb the balance of reliability inherent in the overall concept or structural system. The implications involved in modifications, therefore, must be considered in relation to the overall reliability of all offshore structural systems. The International Standards on offshore structures prepared by TC 67/SC 7 are intended to provide wide latitude in the choice of structural configurations, materials and techniques without hindering innovation. Sound engineering judgment is, therefore, necessary in the use of these documents. This document states the general principles and basic requirements for the site-specific assessment of the in

Scope: This document specifies requirements and guidance for the installation on and removal from site of independent leg jack‑ups for use in the oil and gas industries including lower carbon energy. It addresses the assessment of: a) the installation operation from when the jack-up enters the defined safety zone of the host platform or the intended site to when it is elevated to the operating hull elevation above LAT and is ready for operations; b) the removal operation from when the jack-up is ready to jack-down to when it departs the defined safety zone. NOTE 1 Whilst this document is for independent leg jack-ups, many of the provisions can be applied to mat- supported jack-ups. When the jack-up has propulsion assist or is self-propelled, the provisions of this document related to positioning can be replaced or supplemented as appropriate. This document excludes the move of the jack-up between sites and elevated operations, which are covered respectively by IMO/Class and ISO 19905-1. NOTE 2 Whilst this document addresses the installation and removal of a jack-up at a site, RMPs normally include the move of the jack-up between sites (see example RMP in Annex E).

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 19905-4-2026 PDF

ISO 19905-4-2026 PDF

$162.00 $324.00