Additive manufacturing — General principles — Main characteristics and corresponding test methods
Introduction: Additive manufacturing is a process of joining materials to make parts from 3D model data, usually layer upon layer, as opposed to subtractive manufacturing and formative methodologies. It is used to manufacture prototypes and production parts. This document aims to offer recommendations and advice to machine manufacturers, feedstock suppliers, AM system users, part providers, and customers, to improve communication between these stakeholders concerning test methods. This document has been developed within a set of consistent documents from terminology to test methods and data exchange. Additive manufacturing processes require the selective application of thermo-physical and/or chemical mechanisms to generate the part. Thus, it is possible to produce parts with different characteristics, depending on the method and the process parameters used. However, complete testing of all characteristics for every part is neither cost-effective nor technologically feasible. Therefore, when formulating parts specifications, the nature and scope of testing is an important issue. This document provides an overview of test methods for the characterization of the mechanical properties of metals, ceramics and polymers. It lists all the applicable standards based on specimens manufactured in a traditional process and gives the complement applicable when these specimens are manufactured by additive manufacturing. At the time of publication of this document, the state of the art does not allow to
Scope: This document specifies the principal requirements applied to the testing of parts produced by additive manufacturing processes. This document — identifies quality characteristics for feedstock and parts and the corresponding test procedures, — provides the specific procedures to build specimens using additive manufacturing process, and — recommends the scope and content of test and supply agreements. This document is aimed at machine manufacturers, feedstock suppliers, AM system users, part providers, and customers to facilitate the communication on main quality characteristics. It applies wherever additive manufacturing processes are used. NOTE It is the intent to include, in future versions of this document, other characteristics such as thermal properties, electrical requirements and physical and physico-chemical properties based upon material types.