Additive manufacturing — Feedstock materials — Part 1: Guidelines for the selection of measurement methods for characterization of powder flow properties
Introduction: The increased application of additive manufacturing creates a demand by stakeholders for a guidance document which describes process characteristics and performance regarding general test methods for the characterization of powder flow properties. In powder feedstock based processes, the flow properties of the powder are of decisive importance related to the process reliability of an additive manufacturing process and the quality of the manufactured parts. Characterization of powder flow properties is subject to numerous variables. The meaningfulness of the results of the measurement therefore depends on these variables. However, complete consideration of all variables might be neither cost-effective or time effective. Therefore, when measuring the flow properties, the nature and scope of the measurements to be conducted is an important issue. The information contained in the document is applicable to the conditions that have an influence on flow properties, and the necessary information in a test report. This information is provided is of interest to test equipment manufacturers, material suppliers, additive machine manufacturers, and additive manufacturing machine users. © ISO/ASTM International 2025 – All rights reserved
Scope: The document offers guidance on the selection of an appropriate method(s) to measure the flow properties of powders for powder feedstock based additive manufacturing processes. This document offers several definitions and parameters that affect powder flowability, in addition to several references for additional definitions and parameters. It is intended that the guidance provided in this document not only applies to the virgin condition of the powder but also the used powder as a result of any number of successive builds. It is well known that the physical behaviour of the powder is also affected by the manufacturing process itself during the recovery and sieving cycles of the powder during the production processes. This condition of the powder going back into the system can be called out and monitored from successive builds to detect any drift of the powder properties. This document applies to: — the conditions that have an influence on flow properties, and — the necessary information in a test report. This document is aimed for test equipment manufacturers, material suppliers, additive machine manufacturers, and additive manufacturing machine users.