ISO/IEC FDIS 62752-2015 PDF

ISO/IEC FDIS 62752-2015 PDF

In-Cable Control and Protection Device for mode 2 charging of electric road vehicles (IC-CPD)

$162.00 $324.00 -50%
Product Code: ISO/IEC FDIS 62752
Stock In Stock
Edition: 15
Published: 11/06/2015
Number of Pages: 164
File Size: 1 file, 1.3 MB

Available Options

Product Description

In-Cable Control and Protection Device for mode 2 charging of electric road vehicles (IC-CPD)

Introduction: The essential purpose of this standard is safe and reliable access of electric vehicles to a supply system. The definition for mode 2 charging of electric vehicle is described in IEC 61851-1. For all charging modes, protection against electric shock in case of failure of basic protection and/or fault protection is provided, at least by a type A RCD (see IEC 60364-7-722 and IEC 61851-1). For mode 2 charging including the situation where it cannot be guaranteed that the installation is equipped with RCDs, for example charging the electric vehicle at an unknown installation, a dedicated protection is used for the connected electric vehicle. The intention of this standard is to describe the relevant requirements for an in-cable control and protection device (IC- CPD) to be used for mode 2 charging. The IC-CPD is not a protection device for use in fixed installations.

Scope: This International Standard applies to in-cable control and protection devices (IC-CPDs) for mode 2 charging of electric road vehicles, hereafter referred to as IC-CPD including control and safety functions. This standard applies to portable devices performing simultaneously the functions of detection of the residual current, of comparison of the value of this current with the residual operating value and of opening of the protected circuit when the residual current exceeds this value. The IC-CPD according to this standard has a control pilot function controller in accordance with IEC TS 62763; checks supply conditions and prevents charging in case of supply faults under specified conditions; may have a switched protective conductor. These IC-CPDs are intended for use in TN-, and TT-systems. The use of IC-CPDs in IT systems may be limited. Residual currents with frequencies different from the rated frequency, d.c. residual currents and specific environmental situation are considered. This standard is applicable to IC-CPDs performing the safety and control functions as required in IEC 61851-1 for mode 2 charging of electric vehicles. This standard is applicable to IC-CPDs for single-phase circuits not exceeding 250 V or multi- phase circuits not exceeding 480 V, their maximum rated current being 32 A. NOTE 1 In Denmark, the following additional requirement applies: for IC-CPDs supplied with a plug for household and similar use the maximum charging current is 8 A, if the charging cycle can exceed 2 h. NOTE 2 In Finland, the following additional requirement applies: for IC-CPDs supplied with a plug for household and similar use the maximum charging current is 8 A for long lasting charging. This standard is applicable to IC-CPDs to be used in a.c. circuits only, with preferred values of rated frequency 50 Hz, 60 Hz or 50/60 Hz. IC-CPDs according to this standard are not intended to be used to supply electric energy towards the connected grid. This standard is applicable to IC-CPDs having a rated residual operating current not exceeding 30 mA and are intended to provide additional protection for the circuit downstream of the IC-CPD in situations where it cannot be gu

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO/IEC FDIS 62752-2015 PDF

ISO/IEC FDIS 62752-2015 PDF

$162.00 $324.00