ISO TS 10300-20-2021 PDF

ISO TS 10300-20-2021 PDF

Calculation of load capacity of bevel gears-Part 20: Calculation of scuffing load capacity-Flash temperature method

$96.50 $193.00 -50%
Product Code: ISO TS 10300-20
Stock In Stock
Edition: 1ST
Published: 04/2021
Number of Pages: 30
File Size: 1 file, 3 Bytes

Available Options

Product Description

Calculation of load capacity of bevel gears — Part 20: Calculation of scuffing load capacity — Flash temperature method

Introduction: The ISO 10300 series consists of International Standards, Technical Specifications (TS) and Technical Reports (TR) under the general title Calculation of load capacity of bevel gears (see Table 1). — International Standards contain calculation methods that are based on widely accepted practices and have been validated. — TS contain calculation methods that are still subject to further development. — TR contain data that is informative, such as example calculations. The procedures specified in ISO 10300 parts 1 to 19 cover fatigue analyses for gear rating. The procedures described in ISO 10300 parts 20 to 29 are predominantly related to the tribological behaviour of the lubricated flank surface contact. ISO 10300 parts 30 to 39 include example calculations. The ISO 10300 series allows the addition of new parts under appropriate numbers to reflect knowledge gained in the future. Requesting standardized calculations according to the ISO 10300 series without referring to specific parts requires the use of only those parts that are currently designated as International Standards (see Table 1 for listing). When requesting further calculations, the relevant part or parts of the ISO 10300 series need to be specified. Use of a Technical Specification as acceptance criteria for a specific design need to be agreed in advance between manufacturer and purchaser. Table 1 — Parts of ISO 10300 series (status as of DATE OF PUBLICATION) Calculation of load capacity of bevel gears International

Scope: This document provides a calculation method for bevel and hypoid gears regarding scuffing based on experimental and theoretical investigation[7]. This calculation method is a flash temperature method. The formulae in this document are intended to establish uniformly acceptable methods for calculating scuffing resistance of straight, helical (skew), spiral bevel, Zerol and hypoid gears made of steel. They are applicable equally to tapered depth and uniform depth teeth. Hereinafter, the term “bevel gear” refers to all of these gear types; if not the case, the specific forms are identified. A calculation method of the scuffing load capacity of bevel and hypoid gears based on an integral temperature method is not available when this document is published. The formulae in this document are based on virtual cylindrical gears and restricted to bevel gears whose virtual cylindrical gears have transverse contact ratios of εvα < 2. The results are valid within the range of the applied factors as specified in ISO 10300-1 (see ISO 6336-2). Additionally, the given relations are valid for bevel gears of which the sum of profile shift coefficients of pinion and wheel is zero (see ISO 23509).

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO TS 10300-20-2021 PDF

ISO TS 10300-20-2021 PDF

$96.50 $193.00