Cutting tool data representation and exchange - Part 71: Graphical data layout - Creation of documents for standardized data exchange: Graphical product information
Introduction: This part of ISO/TS 13399 defines the terms, properties and definitions of the drawing frame and drawing content of a computer-aided design. The purpose of this part of ISO/TS 13399 is to provide a common way of an electronic data exchange of graphical product information. However, the aim is the simplified communication during the phase of documentation — namely on the basis of 2D drawings. Within the 2D drawing, the aim is to separate the proper product description (2D graphic) from the users specific presentation (drawing header). Most of the design orders are forced to use the individual drawing frames of the users. Therefore, a big portion of the design expenditure is used for the creation of the documentation and not for the proper problem solution. Drawings are the most important communicative devices of a producing company. Besides the description of complex workpiece geometries, most cases are requests for correspondent documentation, e.g. to support NC-programming or production facilities. This part of ISO/TS 13399 defines a standardized data exchange format for documentation. Therefore, the effort for maintenance of the documentation is reduced because the product drawing of the supplier or manufacturer is merged automatically into the individual drawing frames of the end users. This concept provides advantage for both supplier/manufacturer and end user, since the particular template is centrally maintained once only. To support a standardized electronic product da
Scope: This part of ISO/TS 13399 determines the elements to be used for the creation of 2D documentation. The individual parts of documentation are drawing content, geometrical data, drawing frame and drawing header data as shown in Figure 1. The standardization of drawing formats, e.g. drawing frame, structure of the bill of material, are out of the scope of this part of ISO/TS 13399. Furthermore, it is intended to standardize the data exchange of the product documentation. This part of ISO/TS 13399 specifies a common way for the basic principles for the creation of product documentation that contain the following: — definitions and identifications of the elements of a product documentation; — definitions and identifications of the internal structure of the product documentation; — definitions and identifications of those elements and features that are necessary to show the protection notices and the copyrights of the originator of the document. The following are outside the scope of this part of ISO/TS 13399: — layer settings as defined in ISO/TS 13399-70; — structure of the data exchange file using extensible mark-up language (XML); — applications where these standard data may be stored or referenced; — concept of the classification of cutting tool data and their properties; — concept of the design of 2D drawings for cutting tools; — concept of the design of 3D models for cutting tools; — application data for the use of those cutting tools; — information about the reconditioning of cutting tools; — information about additional application and usage data (e.g. coolant supply).