ISO TR 25269-2026 PDF

ISO TR 25269-2026 PDF

Rolling bearings-Calculation of theoretical reliability

$48.00 $96.00 -50%
Product Code: ISO TR 25269
Stock In Stock
Edition: 1.
Published: 05/2026
Number of Pages: 14
File Size: 1 file, 530 KB

Available Options

Product Description

Rolling bearings — Calculation of theoretical reliability

Introduction: The fatigue lives of a population of rolling bearings are subject to a large statistical variation, that is usually described by a Weibull distribution.[1] This Weibull distribution also is one fundamental concept in the statistical accumulation of failure probability used in the analysis of load ratings and rating life of rolling bearings per ISO 281 and ISO 16281, see ISO/TR 1281-1[2]. However, since rolling contact fatigue life can be described both by a two-parameter as well as a three- parameter Weibull distribution, different methods have been proposed for the reliability analysis of rolling bearings. This document describes a method for the calculation of the theoretical reliability of rolling bearings that is consistent with the provisions of both ISO 281 and ISO 16281, as well as VDMA 23904[3] and IEC/TS 61400-4-1[4]. © ISO 2026 – All rights reserved

Scope: This document contains information on the reliability analysis for rolling bearings. The method described only pertains to the fatigue life per ISO 281 or ISO 16281 of rolling bearings. Other mechanisms of failure, like wear, microspalling (gray-staining) or white etching cracks (WEC), lie outside the scope of this document. A multi-row rolling bearing is considered as a single rolling bearing in the context of this document. The method is based on the life analysis per ISO 281 or ISO 16281, thus the general directions and limitations given in these documents apply. The calculated theoretical reliability is not suitable as the only criterion to select or optimize a rolling bearing or rolling bearing arrangements in powertrains, because the actual bearing reliability in service is also dependent on minimum load, rolling element slip, lubricant and lubricant supply, and heat dissipation. The calculated theoretical reliability does not replace or substitute any safety factors used for consideration of uncertainties in load assumptions, e.g. operation factors for shock loads.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO TR 25269-2026 PDF

ISO TR 25269-2026 PDF

$48.00 $96.00