ISO TR 5262-2023 PDF

ISO TR 5262-2023 PDF

Motorcycles-Guideline for verification of total running resistance force during mode running on a chassis dynamometer

$71.50 $143.00 -50%
Product Code: ISO TR 5262
Stock In Stock
Edition: 1.
Published: 06/2023
Number of Pages: 22
File Size: 1 file, 3 Bytes

Available Options

Product Description

Motorcycles — Guideline for verification of total running resistance force during mode running on a chassis dynamometer

Introduction: A mechanical inertia chassis dynamometer (Formula (1)) is a device with a mechanical flywheel, whereas a chassis dynamometer (Formula (2)) using the electric inertia function is not equipped with such a mechanical flywheel equivalent to inertia mass system and the inertia force is electrically set in the same way of the running resistance force control (Figure 1). The inertia force is generated by the acceleration and/or deceleration, therefore, it is necessary to check the performance of electric inertia function during the mode running test and ISO 18580 specifies the method to verify the chassis dynamometer operated normally. However, ISO 18580 does not provide a threshold for the verification result, and it is difficult to determine its validity. Therefore, we investigate the effect of factors affecting fuel consumption on ISO 18580 verification results, and propose a technical report that shows the guideline for determining the threshold of the verification result. a) mechanical inertia b) electrical inertia Key dynamometer tire roller flywheels acceleration resistance rolling resistance aerodynamic drag resistance NOTE The symbols are defined in Clause 4. Figure 1 — The principle of mechanical and electrical inertia dynamometer © ISO 2023 – All rights reserved

Scope: This document shows the results of investigating the guideline for determining the threshold of the evaluation result on an electric inertial chassis dynamometer that electrically controls the amount of inertia using fuel consumption. This document is applicable when the running resistance force of a chassis dynamometer is set in accordance with ISO 18580.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO TR 5262-2023 PDF

ISO TR 5262-2023 PDF

$71.50 $143.00