ISO TR 5503-2026 PDF

ISO TR 5503-2026 PDF

Preparation of steel substrates before application of paints and related products-Non-visible residues after surface preparation with single use abrasives-Relationship between conductivity (Bresle) measurements and surface soluble salt composition on panels blasted with single-use mineral abrasives

$48.00 $96.00 -50%
Product Code: ISO TR 5503
Stock In Stock
Edition: 1.
Published: 09/2026
Number of Pages: 16
File Size: 1 file, 480 KB

Available Options

Product Description

Preparation of steel substrates before application of paints and related products — Non-visible residues after surface preparation with single use abrasives — Relationship between conductivity (Bresle) measurements and surface soluble salt composition on panels blasted with single-use mineral abrasives

Introduction: Due to the decreasing availability of slag from coal-fired power plants used as single-use aluminium silicate abrasive blasting media, other types of single-use abrasive blasting media are being utilized. When inspecting abrasive blasting work, the salt content is measured using the Bresle test by translating conductivity into salt content. For abrasive blasting work, it is expected that the chloride content on the abrasive blasted surface is low as it increases the lifespan of paint systems (see ISO/TR 15235[9] and Reference [10]). When using other single-use abrasive blasting media, salt content is often measured above the maximum threshold through conductivity, resulting in rejection of the abrasive blasting work. However, the abrasive blasting media meets the allowed chloride content according to the standard. The remedy is then to rinse with fresh water and then re-blast without reducing the conductivity. Conductivity can be caused by multiple salts. Conductivity arises from any water‑soluble salts on the surface and is non‑specific. High readings can reflect corrosion‑promoting salts or other ions that can be less aggressive or even inhibitive in solution. However, soluble salt residue can drive moisture uptake and blistering under coatings. The Bresle test refers to the test as described in ISO 8502-6 (extraction) and ISO 8502-9 (calculation). The document is informative and intended to support understanding of Bresle test results rather than to prescribe testing proce

Scope: This document evaluates the use of the Bresle test (as defined in ISO 8502-9) for assessing soluble salt contamination on steel surfaces prepared with single-use abrasive blasting media. It presents comparative data from field and laboratory measurements using different analytical methods to determine whether conductivity values obtained from the Bresle test can be correlated to chloride and other salt concentrations.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO TR 5503-2026 PDF

ISO TR 5503-2026 PDF

$48.00 $96.00