ASTM A576-25 PDF

ASTM A576-25 PDF

Standard Specification for Steel Bars, Carbon, Hot-Wrought, Special Quality

$36.00 $72.00 -50%
Product Code: ASTM A576
Stock In Stock
Published: 2025
Number of Pages: 6

Available Options

Product Description

This specification covers hot-wrought special quality carbon steel bars. Special quality bar applications include forging, heat treating, cold drawing, machining, and many structural uses. The steel shall be made by one or more of the following primary processes: open-hearth, basic-oxygen, or electric furnace. The heat analysis shall conform to the requirements for chemical composition specified.
 Scope
 1.1  This specification covers hot-wrought special quality carbon steel bars. Special quality bar applications include forging, heat treating, cold drawing, machining, and many structural uses. A guide for the selection of steel bars is contained in Practice A400 .
 1.2  The bars shall be furnished in the grades specified in Table 1 . Sections and sizes of bar steel available are covered in Specification A29/A29M . Hot-wrought special quality carbon steel bars are produced in cut lengths and coils; the manufacturer should be consulted regarding sections and sizes available in coils, produced to a chemical composition.
 Rephosphorized and Resulfurized Carbon Steel E, G, H
 Designation
 Grade
 Carbon
 Manganese
 Phosphorus
 Sulfur
 Lead
 G12110
 1211
 0.13 max
 0.60–0.90
 0.07–0.12
 0.10–0.15
 ...
 G12120
 1212
 0.13 max
 0.70–1.00
 0.07–0.12
 0.16–0.23
 ...
 G12130
 1213
 0.13 max
 0.70–1.00
 0.07–0.12
 0.24–0.33
 ...
 G12150
 1215
 0.09 max
 0.75–1.05
 0.04–0.09
 0.26–0.35
 ...
 ...
 12L14
 0.15 max
 0.85–1.15
 0.04–0.09
 0.26–0.35
 0.15–0.35
 1.3  Merchant quality hot-wrought carbon steel bars are covered in Specification A575 .
 1.4  Some end uses may require superior surface quality, or special chemical restrictions, metallurgical characteristics, heat treatment, or surface finishes which the purchaser may obtain by designating one or more of the available Supplementary Requirements.
 1.5  The values stated in inch-pound units are to be regarded as standard.
 1.6   This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ASTM A576-25 PDF

ASTM A576-25 PDF

$36.00 $72.00