ASTM A450/A450M-25a PDF

ASTM A450/A450M-25a PDF

Standard Specification for General Requirements for Carbon and Low Alloy Steel Tubes

$36.00 $72.00 -50%
Product Code: ASTM A450/A450M
Stock In Stock
Published: 2025
Number of Pages: 10

Available Options

Product Description

This specification covers carbon and low alloy steel tubes. Steel samples shall be melt processed and shall either be ingot cast or strand cast. Heat and product analyses shall be performed on the steel materials. Steel specimens shall also undergo tensile tests and shall conform to required values of yield strength and elongation. Flattening test, reverse flattening test, flaring test, flange test, hardness test, hydrostatic test, air underwater pressure test, and nondestructive tests shall be performed on the steel materials.
 Scope
 1.1  This specification 2 covers a group of requirements which, with the exceptions of 6.3 and Sections 7 , 8 , 19 , 20 , 21 , 22 , 23 , 24 , and 25 , are mandatory requirements to the following ASTM tubular product specifications: 3
 Title of Specification
 ASTM Designation A
 Electric-Resistance-Welded Carbon Steel and Carbon-Manganese Steel Boiler Tubes
 A178/A178M
 Seamless Cold-Drawn Low-Carbon Steel Heat-Exchanger and Condenser Tubes
 A179/A179M
 Seamless Carbon Steel Boiler Tubes for High-Pressure Service
 A192/A192M
 Seamless Medium-Carbon Steel Boiler and Superheater Tubes
 A210/A210M
 Electric-Resistance-Welded Carbon Steel Heat-Exchanger and Condenser Tubes
 A214/A214M
 Seamless and Electric-Welded Low-Alloy Steel Tubes
 A423/A423M
 Specification for Seamless and Welded Carbon Steel Heat-Exchanger Tubes with Integral Fins
 A498/A498M
 Seamless Cold-Drawn Carbon Steel Feedwater Heater Tubes
 A556/A556M
 Seamless, Cold-Drawn Carbon Steel Tubing for Hydraulic System Service
 A822/A822M
 1.2  One or more of Sections 6.3 , 7 , 8 , 19 , 20 , 21 , 22 , 22.1 , 24 , and 25 apply when the product specification or purchase order has a requirement for the test or analysis described by these sections.
 1.3  In case of conflict between a requirement of the product specification and a requirement of this general requirement specification only the requirement of the product specification need be satisfied.
 1.4  The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. The inch-pound units shall apply unless the “M” designation (SI) of the product specification is specified in the order.
 1.5   This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ASTM A450/A450M-25a PDF

ASTM A450/A450M-25a PDF

$36.00 $72.00