ASTM B130-24 PDF

ASTM B130-24 PDF

Standard Specification for Commercial Bronze Strip for Bullet Jackets

$36.00 $72.00 -50%
Product Code: ASTM B130
Stock In Stock
Published: 2024
Number of Pages: 7

Available Options

Product Description

Significance and Use
 17.1  For purposes of determining compliance with the specified property limits for the properties listed in the following table, an observed value of a calculated value shall be rounded as indicated in accordance with the rounding method of Practice E29 :
 Property
 Rounded Unit for Observed or
 Calculated Value
 Chemical composition
 Hardness
 nearest unit in the last right-hand
 significant digit used in expressing
 the limiting value.
 Tensile strength
  nearest ksi (5 MPa)
 Grain size:
  Up to 0.055 mm, incl
  nearest multiple of 0.005 mm
  Over 0.055 mm to 0.160 mm, incl
  nearest 0.01 mm
 Elongation:
  5 % and over
  nearest 1 %
 Abstract
 This specification covers the standard for commercial bronze strip for manufacture of bullet jacket cups and ammunition components from copper alloy UNS No. C22000. The specimens shall be manufactured by such hot working, cold working, and annealing processes to produce a uniform wrought structure. Each specimen shall be subjected to tension test and Rockwell hardness test. In addition to tensile properties for strips, purchaser may also specify grain size. If specimens fail to conform to the prescribed specification, analysis shall be made on a new composite sample.
 Scope
 1.1  This specification covers the requirements for commercial bronze strip for manufacture of bullet jacket cups and ammunition components from Copper Alloy UNS No. C22000. 2
 1.2   Units— The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
 1.3   The following safety hazard caveat pertains only to the test methods described in this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
 1.4   This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ASTM B130-24 PDF

ASTM B130-24 PDF

$36.00 $72.00