ASTM B188-15(2023) PDF

ASTM B188-15(2023) PDF

Standard Specification for Seamless Copper Bus Pipe and Tube

$36.00 $72.00 -50%
Product Code: ASTM B188
Stock In Stock
Published: 2023
Number of Pages: 10

Available Options

Product Description

Significance and Use
 18.1  For purposes of determining compliance with the specified limits for requirements of the properties listed in the following table, an observed value or a calculated value shall be rounded as indicated in accordance with the rounding method of Practice E29 .
 Property
 Rounded Unit for Calculated or Observed Value
  Chemical composition
 nearest unit in the last right-hand place of figures
   of the specified limit
  Hardness
  Electrical resistivity
 nearest unit in the last right-hand place of figures
  Electrical conductivity
  Tensile strength
 nearest ksi (5 MPa)
  Elongation: below 5 %
 nearest multiple of 0.5 %
  5 % and over
 nearest 1 %
 Abstract
 This specification covers seamless copper bus pipe and tube intended for use as electrical conductors. The material shall be manufactured by such hot-working, cold-working, and annealing processing as to produce a uniform, seamless wrought structure in the finished product. The method of manufacture shall be such that the finished material conforms to the specified temper properties. The material shall conform to the requirements for the copper UNS no. as specified. The material shall be furnished in either the O60 (soft anneal) or H80 (hard drawn) temper. The material shall conform to the maximum electrical resistivity requirements prescribed. The product shall conform to the prescribed mechanical property requirements. The product shall conform to the prescribed bend testing requirements. The test specimens of material designated as Copper UNS Nos. C10100, C10200, C10300, C10400, C10500, C10700, and C12000 shall be free of cuprous oxide. When tested, material designated as Copper UNS nos. C10100, C10200, C10300, C10400, C10500, C10700, and C12000 shall pass the embrittlement test. The product shall be passed through an eddy-current testing unit adjusted to provide information on the suitability of the product for the intended application.
 Scope
 1.1  This specification establishes the requirements for seamless copper bus pipe and tube intended for use as electrical conductors.
 1.1.1  The product shall be made from one of the following coppers, as denoted in the ordering information: 2
 Copper UNS No. 2
 Previously Used Designation
 Type of Copper
   C10100
  OFE
 Oxygen-free, electronic
   C10200
 OF
 Oxygen-free without residual deoxidants
   C10300
 —
 Oxygen-free, extra low phosphorus
   C10400, C10500,    C10700
  OFS
 Oxygen-free, silver bearing
   C11000
  ETP
 Electrolytic tough pitch
   C11300, C11400,    C11600
  STP
 Silver-bearing tough pitch
   C12000
  DLP
 Phosphorized, low residual phosphorus
 1.2  Unless otherwise specified, any one of the above coppers may be furnished.
 1.3   Units— The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units, which are provided for information only and are not considered standard.
 1.4   This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ASTM B188-15(2023) PDF

ASTM B188-15(2023) PDF

$36.00 $72.00