ASTM B248M-22 PDF

ASTM B248M-22 PDF

Standard Specification for General Requirements for Wrought Copper and Copper-Alloy Plate, Sheet, Strip, and Rolled Bar (Metric)

$40.00 $80.00 -50%
Product Code: ASTM B248M
Stock In Stock
Published: 2022
Number of Pages: 13

Available Options

Product Description

Significance and Use
 11.1  For the purposes of determining compliance with the specified limits for requirements of the properties listed in the following table and for dimensional tolerances, an observed value or a calculated value shall be rounded as indicated in accordance with the rounding method of Practice E29 :
 Property
 Rounded Unit for Observed or
 Calculated Value
   Chemical composition
   nearest unit in the last
   Hardness
    right-hand significant digit
   Electrical resistivity
    used in expressing
   Electrical conductivity
    the limiting value
   Tensile strength
   nearest 5 MPa
   Yield strength
   nearest 5 MPa
   Elongation:
   nearest 1 %
   Grain size:
    Under 0.060 mm
   nearest multiple of 0.005 mm
    0.060 mm and over
   nearest 0.01 mm
 Abstract
 This specification establishes the general requirements common to several wrought products including copper and copper-alloy plates, sheets, strips, and rolled bars. The numerical values in this specification are not presented in inch-pound units, but rather, in metric or SI units only. The material for manufacture shall be a cast bar, cake, or slab of such purity and soundness as to be suitable for processing by hot- or cold-working, and annealing to produce a uniform wrought structure in the finished product. The edges shall be slit, sheared, sawed, or rolled, as specified. When rolled edges are required, they may be produced by either rolling or drawing to one of the following specified edge contours: square edges (square corners), rounded corners, rounded edges, and full-rounded edges. Products shall be sampled and prepared, then tested accordingly to examine their conformance to dimensional (thickness, length, width, weight, and straightness), mechanical (tensile and yield strength, Rockwell hardness, and elongation), electrical (resistivity and conductivity), chemical composition, and grain size requirements.
 Scope
 1.1  This specification establishes the general requirements common to several wrought product specifications. Unless otherwise specified in the purchase order or in an individual specification, these general requirements shall apply to copper and copper-alloy plate, sheet, strip, and rolled bar supplied under each of the following product specifications issued by ASTM: B36/B36M , B96/B96M , B103/B103M , B121/B121M , B122/B122M , B130 , B152/B152M , B169/B169M , B422/B422M , B534 , B694 , B888/B888M , and B936 . 2
 1.2   Units— This specification is the companion specification to inch-pound Specification B248 .
 1.3   This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ASTM B248M-22 PDF

ASTM B248M-22 PDF

$40.00 $80.00