Significance and Use
20.1 For purposes of determining compliance with the specified limits for requirements of the properties listed in the following table, an observed value or a calculated value shall be rounded as indicated in accordance with the rounding method of Practice E29 .
Property
Rounded Unit for Observed or Calculated Value
Chemical composition
nearest unit in the last righthand place of figures
Tensile strength and yield strength
nearest ksi (Nearest 5 MPa)
Grain size: Up to 0.055 mm, incl, Over 0.055 mm
nearest multiple of 0.005 mm to the nearst 0.010 mm
Expansion:
nearest 1 %
Abstract
This specification covers welded tube of specific copper and various copper alloys of a limited range of diameters, for use in surface condensers, evaporators, heat exchangers, and general engineering applications. The product shall be manufactured by forming the material into a tubular shape on a suitable forming mill. Welding of tube shall be accomplished by forge-welding, fusion-welding, or full finishing that produces a forge weld leaving no crevice in the weld seam visible to the unaided eye. The tube shall conform to tensile strength and yield strength requirements, and shall be subject to expansion, flattening, and reverse bend tests. Mercurous nitrate or ammonia vapor tests shall be required only for selected UNS Numbers of Copper Alloys. Each tube shall be subjected to eddy-current, hydrostatic, and pneumatic tests.
Scope
1.1 This specification covers the requirements for welded tube of copper and various copper alloys up to 3 1 / 8 in., inclusive, in diameter, for use in surface condensers, evaporators, heat exchangers, and general engineering applications. The following coppers or copper alloys are involved:
Copper or Copper Alloy UNS No. 2
Type of Metal
C10800 A
oxygen-free, low phosphorus
C12200 A
DHP phosphorized, high residual phosphorus
C19400
copper-iron alloy
C23000
red brass
C44300
arsenical admiralty
C44400
antimonial admiralty
C44500
phosphorized admiralty
C68700
arsenical aluminum brass
C70400
95-5 copper-nickel
C70600
90-10 copper-nickel
C70620
90-10 copper-nickel (modified for welding)
C71000
80-20 copper-nickel
C71500
70-30 copper-nickel
C71520
70-30 copper-nickel (modified for welding)
C71640
copper-nickel-iron-manganese
C72200
...
1.2 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, SI units are shown in brackets. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
1.3 The following safety hazard caveat pertains only to the test method(s) described in this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
Warning— Mercury has been designated by many regulatory agencies as a hazardous substance that can cause serious medical issues. Mercury, or its vapor, has been demonstrated to be hazardous to health and corrosive to materials. Use caution when handling mercury and mercury-containing products. See the applicable product Safety Data Sheet (SDS) for additional information. The potential exists that selling mercury or mercury-containing products, or both, is prohibited by local or national law. Users must determine legality of sales in their location.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.