ASTM B824-17(2025) PDF

ASTM B824-17(2025) PDF

Standard Specification for General Requirements for Copper Alloy Castings

$36.00 $72.00 -50%
Product Code: ASTM B824
Stock In Stock
Published: 2025
Number of Pages: 6

Available Options

Product Description

Significance and Use
 14.1  For the purpose of determining compliance with the specified limits for requirements of the properties listed in the following table, an observed value or a calculated value shall be rounded as indicated in accordance with the rounding method of Practice E29 .
 Property
 Rounded Limit for Observed or Calculated Value
 Chemical Composition Hardness Electrical Resistivity Electrical Conductivity
 nearest unit in the last right-hand significance digit used in expressing the limiting value
 Tensile Strength
 nearest ksi (5 MPa)
 Yield Strength
 Elongation
 nearest 1 %
 Grain Size:
  Under 0.060 mm
 nearest multiple of 0.005 mm
  0.060 mm and over
 nearest 0.01 mm
 Abstract
 This specification establishes the general requirements common to copper alloy castings of UNS Nos. C94700, C95300, C95400, C95410, C95500, C95520, and C96800. Materials shall be sampled and prepared, then tested accordingly to examine their conformance to mechanical (tensile and yield strength, hardness, and elongation), electrical (resistivity and conductivity), dimensional, chemical composition, and grain size requirements. In the event of conflict between this specification and the individual casting product specifications, the requirements of the casting specification shall take precedence.
 Scope
 1.1  This specification establishes general requirements common to ASTM copper alloy casting Specifications B22/B22M , B61 , B62 , B66 , B67 , B148 , B176 , B271/B271M , B369 , B427 , B505/B505M , B584 , B763/B763M , B770 , and B806 . These requirements apply to the casting specifications to the extent referenced therein.
 1.1.1  In the event of conflict between this specification and a casting specification, the requirements of the casting specification shall take precedence.
 1.2  The chemical composition and other requirements not included in this specification shall be prescribed in the casting product specifications.
 1.3   Units— The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
 1.4  No precise quantitative relationship can be stated between the properties of the metal in various locations of the same casting or between the properties of castings and those of a test bar casting from the same metal. (See Appendix X1 .) 2
 1.5   This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ASTM B824-17(2025) PDF

ASTM B824-17(2025) PDF

$36.00 $72.00