ASTM B952/B952M-19(2024) PDF

ASTM B952/B952M-19(2024) PDF

Standard Specification for Zinc Alloys in Ingot Form for Spin Casting

$32.00 $64.00 -50%
Product Code: ASTM B952/B952M
Stock In Stock
Published: 2024
Number of Pages: 2

Available Options

Product Description

This specification covers four zinc alloys in ingot form, namely: Spin Casting Alloy SC-A, Spin Casting Alloy SC-B, Spin Casting Alloy SC-C, and ZA-73, for remelting for the manufacture of spin castings. The alloys may be made by any approved process, shall be of uniform quality, and shall be free from dross or other harmful contamination. The ingots shall conform to the chemical composition limits prescribed for aluminum, magnesium, copper, iron, lead, cadmium, tin, nickel, and zinc. Chemical analysis requirements for determination and for verification (if needed) of chemical composition are detailed.
 Scope
 1.1  This specification covers zinc alloys in ingot form for remelting for the manufacture of Spin Castings as specified and designated, as shown in Table 1 . Seven alloy compositions are specified, designated as follows:
 Common
 Traditional
 UNS
 Spin Casting Alloy SC-A
 ...
 Z35550
 Spin Casting Alloy SC-B
 ...
 Z35551
 Spin Casting Alloy SC-C
 ...
 Z35534
 Spin Casting Alloy SC-D
 HJ10
 Z35547
 Spin Casting Alloy SC-E
 HJ20
 Z35548
 Spin Casting Alloy SC-F
 HJ40
 Z35552
 ZA-73
 ...
 Z36500
 1.2  Zinc alloys #2, #3, #5, and ZA-8 specified in Specification B240 are also used in the spin casting process.
 1.3  The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
 1.4   This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Safety Data Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety, health, and environmental practices, and determine the applicability of regulatory limitations prior to use.
 1.5   This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ASTM B952/B952M-19(2024) PDF

ASTM B952/B952M-19(2024) PDF

$32.00 $64.00